No 12 V power to fan motor connector. I think green wire should be 12 Volts, but can't find a diagram I can read. By the time I make the on-line diagrams big enough to see, they are too fuzzy to read!! Blower runs fine when I put power on the connector. None of the speeds work normally. It's probably a fuse, but everything looks good! AC Compressor works fine, cycles on and off normally. Question: Doesn't the blower resistor switch between the motor and ground?
SOURCE: 2000 cherokee sport blower motor control
It is a bad blower motor resistor and it is mounted on the bottom of the A/C heater housing on the passenger side of the vehicle under the glovebox area. Hope this helps. Please rate this a fixya if it helps. Thanks.
Mike
SOURCE: how to replace a blower motor resistor in a 2004 jeep liberty
You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.
SOURCE: 1999 Jeep Wrangler 4cyl W/AC, Blower quit,
Run a new wire to the motor from the switch this will do 2 things for you. It will tell you if your switch is still good, and if it works you just fixed your problem.
tepfy
SOURCE: 1995 Jeep Cherokee AC blower doesn't work.
do you have feed to blower motor ?? sorry CSI is coming on TV now and er indoors is screaming that i spent too long on here '¡'¡'¡'¡'¡ usual ----typical woman ,if you have her i will throw my jag in the deal for free
879 views
Usually answered in minutes!
×