Where is the alternator located on a 93 ford taurus with a 3.0 engine

SOURCE: location of thermostat on a ford taurus 1999 for replacement

Follow the top radiator hose to the engine,the thermostat is behind the housing where the hose is connected to.

SOURCE: WHERE IS THE OIL SENDING UNIT LOCATED ON A 93 FORD TAURUS

The oil pressure sending unit is located behind the oil filter.

SOURCE: need diagram of serpentine belt for 94Solution for "need diagram for replacing serpentine belt for 94 ford taurus gl w/3 0 v6 engine and a/c" ford taurus gl w/3.0 v6 engine and a/c

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

SOURCE: 2005 ford taurus engine light on

Try disconnecting the battery for 10 mins.This may reset the lights timer. If it comes back on within the next few days the take it to a large auto parts store and most will bring their computer out and hook it to your car and read the code the light will leave in your car computer,then they tell what the code says and try to sell you the part.You might car the auto parts store first and tell them what you have and ask if then can read your code for you.Its usually a free service.

Wayne Fellows

• 262 Answers
• Posted on Mar 14, 2010

SOURCE: alternator removal 1998 ford taurus dohc

3.0L (4V)
Removal

1. Disconnect the battery ground cable.
   

1. Remove the accessory drive belt from the generator pulley.
   

1. Remove the power steering line bracket and heater hose support bracket from the generator.
   

1. Remove the upper generator bolts.
   

1. Partially raise the vehicle on a hoist.
   

1. Remove the right front wheel.
   

1. Remove the lower fender splash shield retainers and position the shield out of the way.
   

1. Remove the generator splash shield.
   

1. Raise the vehicle.
   

1. Disconnect the electrical connector and remove the battery positive cable from the generator.
   

1. Position an adjustable stand to the subframe.
   

1. Remove the right subframe bolts.
   

1. Remove the lower generator bolt.
   

1. Lower the subframe to provide clearance.
   

1. Remove the generator.
   

1. NOTE: Do not tighten the lower bolt.
   
   Install the generator and the lower bolt.
   

1. Raise the subframe and install the subframe bolts. Tighten the bolts to 90 Nm (66 lb-ft).
   

1. Remove the adjustable stand.
   

1. Lower the vehicle.
   

1. Install the upper generator bolts and tighten them to 25 Nm (18 lb-ft).
   

1. Install the power steering line bracket and the heater hose support bracket. Tighten the nut to 20 Nm (15 lb-ft).
   

1. Install the accessory drive belt. Refer to Partially raise the vehicle.
   

1. Tighten the lower generator bolt to 25 Nm (18 lb-ft).
   

1. Connect the generator electrical connector.
   

1. Install the battery positive B+ cable and nut. Tighten the cable nut to 10 Nm (89 lb-in).
   

1. Install the generator splash shield.
   

1. Install the fender splash shield and the retainers.
   

1. Install the right front wheel.
   

1. Lower the vehicle.
   

1. Connect the negative battery cable.