Changing the headlights

Sounds like you need to look for a bad ground for the passenger headlight.

Most total headlight failures are caused by a bad component like a fuse, relay, or module. Wiring problems can also cause both headlights to stop working. High beam headlights don't work or low beams don't work. If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Check your manual to find your headlamp relay.

Here's a link on replacing your light bulb on your VW. Sparky Answers 2001 VW Beetle Changing The Low Beam Headlight Bulb HERE'S A VIDEO,ALSO How To Change Head Light Bulb VW Beetle

check for a damaged wire for the low beam. Also wouldn't hurt to check the ground wire as the high beam will try and ground through the low beam but not visa verse

HEADLIGHTS NOT WORKING

It can be faulty headlight switch or issue with its wiring. Or its faulty head light fuse.

==========

To troubleshoot the issue i suggest you few help links with appropriate solution. So you can follow the test and confirm what exact problem is there in your case of headlights not working:-----

Click the link below: -----

All headlights not working?

http://repairhelpcenter.blogspot.com/2012/01/all-headlights-not-working.html

----------

• Working of Headlight switch?
------------
• Both headlight bulbs blow together?

------------
• Car headlight bulbs don't last long?

---------------

2007 Dodge Caliber: Low Beam Headlight Not working

http://technoanswers.blogspot.in/2012/06/2007-dodge-caliber-low-beam-headlight.html

----------

2003 Toyota Camry: Headlights Work Intermittently?

http://technoanswers.blogspot.in/2012/04/2003-toyota-camry-headlights-work.html

----------

Chevy Tahoe: Low Beam Lamps are not working?

http://technoanswers.blogspot.in/2012/04/chevy-tahoe-low-beam-lamps-are-not.html

----------

2001 Chevrolet Tahoe: Headlights not coming ON?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-headlights-not.html

--------

2004 Dodge Ram: High Beam Light is DIM?

http://technoanswers.blogspot.in/2012/04/2004-dodge-ram-high-beam-light-is-dim.html

----------

2001 Chevrolet Tahoe: Both Low Beam Lamps Not Working?

http://technoanswers.blogspot.in/2012/04/2001-chevrolet-tahoe-both-low-beam.html

------------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

---------
How to Replace a Headlight

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight.html

------------
How to Replace a Headlight Bulb

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-bulb.html

-----------
How to Replace a Headlight Switch

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-headlight-switch.html

----------
How to Replace a Headlight Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-assembly.html

How to Replace a Park Light Assembly

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-park-light-assembly.html

-----------

Low beam headlights Modification?

http://schematicsdiagram.blogspot.in/2012/04/low-beam-headlights-modification.html

----------

Headlight Assembly Removal On Honda Accord

http://technoanswers.blogspot.in/2012/06/headlight-assembly-removal-on-honda.html

---------------

Honda Headlight Assembly Removal
http://schematicsdiagram.blogspot.in/2012/06/honda-headlight-assembly-removal.html

-----------

How to Replace a Headlight Door

http://schematicsdiagram.blogspot.com/2011/08/how-to-replace-headlight-door.html

----------

How to replace HID headlight bulbs for lexus 400h?

http://schematicsdiagram.blogspot.com/2012/01/how-to-replace-hid-headlight-bulbs-for.html

----------------

These will help.

Thanks.

NO YOU HAVE TO REPLACE HIGH BEAM LIGHT BULBS WITH HIGH BEAM LIGHT BULBS BECAUSE HIGH BEAM LIGHT BULBS AND LOW BEAM LIGHT BULBS TWO DIFFERENT TYPES OF BULBS.WEAR CLEAN LATEX GLOVES HANDLING THE HEADLIGHT BULBS WHICH IS HALOGEN LIGHT BULBS, OIL FROM FINGERS OR HAND WILL CAUSE HALOGEN BULBS TO OVER HEAT BLOW OUT.

Changing the headlight bulb is a little bitdifficult for those not familiar with the vehicle. Both the high and low beamsare encased in a sealed unit, which also contains the turn signal, parkinglights, and side reflector. To change a single headlight, the entire headlightcompartment must be removed from the car. Once you understand how to remove thesealed headlight unit from the car, replacing the bulb is relatively simple.Follow the steps below on how to change the headlamp bulb in this car. Removal 1. Open the hood of the Jeep and locate thelong, headlamp jackscrew. The screw is located almost directly above theheadlight unit and can be removed using a 7-mm socket wrench. This will allowyou to remove the bezel from the grill opening panel. Remove the three screwsattached to the retaining ring to the headlight console. The screws are locatedon the bottom front and side of the unit. In some models the screws have beenreplaced with ball-stud alignment posts, enabling you to remove the headlightunit by simply wiggling it loose. 3. Disconnect the headlamp bulb wireharness connector located at the front of the headlight unit. This is locateddirectly above and between the parking and turning bulbs. 4. Separate the sealed headlight unit fromthe vehicle; disconnect and replace the old bulb. The high beam is locatedtoward the center of the car. The low beam is the bulb on the outermost edge ofthe unit. This is how to Install 1. Reconnect the headlamp bulb's wireharness-connector. Then Replace the headlight unit in the headlight canister. Positionthe retaining ring back in its original position and install the three screwsagain. If you wiggled the unit out, ensure that it is replaced firmly. 2. Install the headlamp bezel by replacingthe 7-mm jackscrew on the inside of the hood. Make sure all connections aretight before starting the car and inspecting the replacement.

Both the low beam bulbs must be defective.
People at Jiffylube change headlight bulbs while you wait, if you are not up to the task.

replace the headlight bulbs. Usually when the bulbs blow out the low beam blows out first, but the high beams still work. If you want and need both low and high beams to work then replace the headlight bulbs with brand new ones and I garauntee that both low and high beams will work

Strange headlamp problems on Saabs can often be attributed to a failing Headlamp relay. Here are a few common situations:
Issue1 - Headlamp switch will work backwards: Turn on the switch and theheadlights go off and turn off the switch and the headlights will goon.
Issue 2 - High beams will disappear. You will have nohighbeams. Be sure to check the headlight bulbs PRIOR to ordering therelay. Remember however that it is possible for both high beams burn out at the same time
Issue3 - High beams will not work only the low beams will.
Issue 4 - A single bulb setting (low or high) on either side will not work and bulb replacement will fix it.
You can sometimesfix these issues by removing the relay, taking off the cover andresoldering the connections on the relay bottom. To perform this repair, go to my illustrated tutorial at customsaab.com.
In some cases youwill have to replace the relay to effect a long term cure. The aftermarket replacement can be had at Eeuroparts.com for about $60.00:
Name: Bulb Check Relay
Part Code: 4109070A
Brand:
Description: Bulb check relay for any 9000 92-98, 900 94-98, 9-3 99-03, 9-5 all.

KAE (Kaehler) made in Germany.
Price: $59.90