I am changing the entire headlamp assembly and need to know the correct way to do it
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: thermostat in 2001 dodge ram 1500
the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure
SOURCE: Reverse light switch on 1995 Dodge Ram 1500
switch is just above trans pan and below shift linkage requires a thin (crome 1" socket) to remove
SOURCE: 1998 dodge ram 1500 2wd 5.9 eng. how to change
just drop the transmission pan to drain it and the filter is right there in the valve body,DON'T mess the band adjustment,they are only to stop the planetary gears so you can go into reverse,there is no such thing as adjusting bands! that went out with the fifties!
SOURCE: Remove headlight assembly from a 2001 Dodge Ram
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
214 views
Usually answered in minutes!
×