2007 Dodge Durango Night Runner New Cars Logo

Related Topics:

A
Anonymous Posted on Sep 04, 2012

How to bleed the abs system on a 2007 dodge durango

5 Related Answers

Anonymous

  • 62 Answers
  • Posted on Apr 19, 2009

SOURCE: 2007 dodge durango

Clock Setting Procedure
1. Press and hold the time button until the hours blink.
2. Adjust the hours by turning the right side Tune /
Audio control.
3. After the hours are adjusted, press the right side Tune /
Audio control to set the minutes.
4. Adjust the minutes using the right side Tune / Audio
control.

Owner's Manual under: INSTRUMENT PANEL AND CONTROLS 195


If this works please give me a rating on my solution, thanks!

OpenSource13


http://www.fixya.com/PostAnswer.aspx?thid=2028796&prdid=696996 where to find your Owner's Manual
4

Ad

Anonymous

  • 721 Answers
  • Posted on Jun 27, 2009

SOURCE: A/C unit in 2007 Dodge Durango

Yep,I'd agree. The difference in coldness is unrelated to the compressor issue. That a bad vent motor or something like that on the heater box in front. Change the "h" valve or otherwise known as the "expansion" valve too.

Anonymous

  • 1 Answer
  • Posted on Jul 10, 2009

SOURCE: 1999 Dodge Durango. Brake Light and the ABS Light

If you backup lights are not working as well, I would say check the fuse for the backup lights, if the fuse is good, see if you are getting power to that fuse. We had this problem and after weeks of searching and changing sensors, we found the backup light fuse was good, but not getting power. Ran a wire from that fuse to the cig. lighter fuse and all woprksf great.

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Oct 18, 2009

SOURCE: Taking apart the dash in my 2007 dodge durango

Experienced mechanics avoid that task.

Anonymous

  • 5 Answers
  • Posted on May 11, 2010

SOURCE: 1999 dodge durango wont start

may work may not...on older cars when the starter went bad and the car wouldn't start you could tap the starter with a long screwdriver or hammer lightly and the solenoid would engage and start the car but you need to get it home or to shop cause it wouldn't work again..if you try this and the starter engages then the starter needs to be replaced if you haven't already tried..if the lights are flashing when you try to start the vehicle then o would say its prob a malfunctioning alarm system..try to diengage it by pulling fuse for alarm..don't know if you can though..check the starter...good luck

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2007 Toyota Avalon XLS. How to bleed the ABS brake system please? Non VSC.

Question edited for clarity.
Question moved to model category.

Best way is to use a pressure bleed system which adds brake fluid under pressure from the caliper and up the the reservoir.

https://www.google.com/search?q=2007+Toyota+Avalon+XLS%2C+bleed+ABS+brakes

..
0helpful
1answer

Bleeding brakes

wheel bearings are wore out so abs isnt working. change them and the abs light and spedo will be fixed. peddle is low because the fluid goes through the not working abs box.
0helpful
1answer

Brake light and abs light won't go off

no what you need to do is disconnect your battery for 30 mins and reconnect it light should go out
0helpful
1answer

I cant get any brake fluid to bleed out of my back brake bleeders valves

You need a special tool to bleed the system due to the ABS brake syastem.
0helpful
1answer

How do you bleed the fuel system on 2005 Dodge Durango 4.7 litre engine?

The system is self bleeding. What is the problem here?
0helpful
1answer

2007 dodge sprinter van brake bleeding

SOME SPRINTERS HAD RECALLS ON MASTER CYLINDERS YEARS 2006-2009 CHECK DEALER FOR MAYBE RECALL,IAM NOT SURE WHY YOUR BLEEDING THE BRAKES IF YOU HAD OPENED A LINE OR CHANGED A CALIPER THERE MABE AIR IN THE LINES-I ALWAYS USE A PRESSURE BLEEDER OR YOU CAN GRAVITY BLEED SYSTEM BY OPENING EACH BLEEDER SCREW UNTILL GOOD FLOW THEN CLOSEING-IF BLEEDING FOR MUSHY PEDAL CHECK BRAKES AND THICKNESS OF ROTORS-ARE THEIR ANY CODES -IS THE ABS LIGHT ON-IF ALL CHECKS OUT GO TO MASTERCYLINDER
0helpful
1answer

Can i replace the abs system and how do i do it in a 2004 dodge durango slt

change all your break calipers. thats wher the abs system is. but chek the ground wires on your calipers 2 make sure that they are all grounded. maybe thats all that is wrong
0helpful
2answers

2000 Dodge Durango XLT - V8. ABS engages each morning at the first stop I make. Nearly throws me through the window.

sounds like the abs is working on going out because it should not ever grab unless you really slam on the brakes, try having the brake system flushed and see if this still happens could have trash in the system.
0helpful
2answers

1998 Dodge caravan. air in abs.

You cant bleed the ABS,this is your anti lock brake system,try to bleed them again,then check your power brake booster,check for loose vacuum hoses.
Not finding what you are looking for?

227 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...