Was closing window with drive power control and at to there was a loud POP and the window started to slide back down in door. stopped by itself after 5 inches but motor has no control of window. Can novice take panel off and chase problem with major savings or will it wind up being significant parts costs and poor weather seal compared to mechanic repair. Did glass break or a fastner?
SOURCE: 1996 Jeep grand Cherokee Larado, rear door stuck
go throu licence plate pannel pull up on bar and on the inside under ur pannel the nut fell off the mechanism so just put on a new nut
SOURCE: Jeep Cherokee door lock repair.
heard of your problem! open drivers door,look at door jam were wiring harness comes out of body,thier be a break in main door harness! peel back rubber boot and tug on wires.
SOURCE: window motor replace 2001 jeep grand cherokee
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
SOURCE: 2002 jeep power windows and door locks stopped
SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE
SOURCE: 1995 Jeep Grand Cherokee power window wire broken
Your best way in is through the kick panel on the side. I generally solder an additional length of wire on and before connecting to other end, slide a piece of thin tubing (like washer fluid line) over it. After soldering the other end, slide the tubing over the repair and put a dab of silicone or other glue on the wire just before you have it all the way in position. Doing this protects the repair and the wire from further failure.Make sure you secure any extra wire inside the door where the window regulator won't grab it and tear it out.
231 views
Usually answered in minutes!
×