Need to know where to find the crankshaft position sensor on a 2006 Chevrolet Malibu?
On 2.2 models remove starter. disconnect 7x crankshaft position sensor wiring harness.remove sensor mounting bolt, with draw sensor, replace o ring and lightly lubricate it with oil.... on 6 cylinder models,..remove the drive belt, jack up car, remove crankshaft pulley. remove sensor bolt and pull out.( noting the wiring harness for installation).
?€¢
Engine control module (ECM) replacement
?€¢
Crankshaft damper replacement
?€¢
Crankshaft replacement
?€¢
CKP sensor replacement
?€¢
Any engine repairs which disturb the crankshaft to CKP sensor relationship
Important: The scan tool monitors certain component signals to determine if all the conditions are met to continue with the CKP system variation learn procedure. The scan tool only displays the condition that inhibits the procedure. The scan tool monitors the following components:
?€¢
CKP sensor activity--If there is a CKP sensor condition, refer to the applicable DTC that set.
?€¢
Camshaft position (CMP) signal activity--If there is a CMP signal condition, refer to the applicable DTC that set.
?€¢
Engine coolant temperature (ECT)--If the engine coolant temperature is not warm enough, idle the engine until the engine coolant temperature reaches the correct temperature.
1,390 views
Usually answered in minutes!
×