I just bought after market headlight assembly units for my 1995 jeep grand Cherokee limited. The ball won't stay in the plastic piece. Won't snap in like the old one did. What do I do?
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE
remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly
SOURCE: serpentine belt on a 1995 jeep grand cherokee
let me know if this looks correct. If not I will find another diagram. Available at google images
SOURCE: change a headlight assembly Jeep Grand Cherokee
Just need take off the screws; for details check the graphics and ilustrations in the Jeep ZJ Grand Cherokee Service Manual
Hope helps (remember rated this) Good luck..
SOURCE: Jeep Grand Cherokee Laredo 1998 headlight assembly instructions
youtube.com type in 1998 grand cherokee headlight assembly, I just fixed mine in 10 minutes, both of them!
1,263 views
Usually answered in minutes!
×