Changed master door switch with no luck, checked all fuses associated with windows and found them to be good. all four windows wont work. thought it might be window regs but seems odd that all 4 went bad at same time. i am going to check regs this weekend. any other suggestions...
Https://postimg.org/image/9gkzxjvh1/
Click on the link.
You can see the fuses, not only check the fuse, check for voltage on fuse circuit, use a test light, goes hot with key on.
On the hinge side of driver door, check the wiring harness. Probably has a protective rubber boot covering, see if you can pull the boot back far enough to get at the proper color. Green wire with blue tracer should be voltage, with key on, use a test light. Also, check the ground wire, it is black. You can use a test light to check ground also. One end of test light touches battery voltage, the other end penetrates that black wire, if the light comes on, the ground is good enough for test light. The driver door is opened and closed so much, sometimes the wires break. If you make a hole in the wire, use finger-nail polish or something to cover the hole.
SOURCE: '00 Ford Explorer - Master window switch won't work rear windows
Without proper electrical diagnostic equipment and based on the very through description that you gave I would suggest getting a new switch. I say a new switch because on the drivers side the switch is one giant junction block. I have the same vehicle and had my door panel off for some locking issues.
I have attached a link to Ford Direct. The part that you are looking for is Window switch, explorer, 4 door, right
http://www.forddirectonline.com/partlocator/index.cfm?action=getLocator&siteid=214462&chapter=DP2028&appSectionid=3&groupid=10005&subgroupid=20061&componentid=62141&make=10&model=Explorer&year=2000&catalogid=1
SOURCE: central locking on Ford focus 1.4 W reg 2000
hi i would start by checking if there is a relay, it seems that there is a delay on the pressure pump that is supposed to shoot the door pins up.
SOURCE: 2005 Ford F-150 driver door power window wont work
yes sounds like you need a motor/regulator need more info go to collisionrepairadvice.com diy or whom to see to save money
SOURCE: Electric Windows
yes, dat can b ur problem. check under the master switch to c if wire is nt loose. u need a test lite to check if power comin to it b4 changing it. easy put ur test lite **** on any metal that dont hav paint. put da sharp point to the wire undre da master switch and press botton, check wires 1by 1 wen u press it da lamp should lite up. oh yeah key must b on on position wile testing
SOURCE: POWER WINDOW FAILURE
you might have a broken wire usually from the door to the windshield pillar inside a rubber insulation
124 views
Usually answered in minutes!
×