Question about Mitsubishi L200
I have a mitsubishi l200 4life 2.5 turbo pick-up 2004,recently I have had some overheating problems,mainly bubbling in the header-tank. Initially replaced thermostat, bled & topped up coolant system all ok for a week or 2, Problem reoccured with slight bubbling in header tank, I replaced thermostat a 2nd time, which I found to be closed on inspection. Repeated the process again and still slight bubbling. Extensive road test 30-40 miles no over heating, gauge steady, water level header tank correct to manufactures recommended level. Unsure if there is an underlying problem such as head gasket failure or whether it is simply incorrect thermostat. Or could is be a normal running issue for this vehicle
I have an l200 animal, i started getting the same symptoms, bubbling noises, over heating, water being discharged into the header tank, i had a good look around the engine,there was no oil in the water or water in the oil ( signs of head gasket failure) when the radiator cap was off and i revved hard nothing happened, no dip in water levels and no splashing out. i took the water pump off and the impellor had sheered off the shaft. fitted a new pump and its been fine, maybe all these cracked cylinder heads and warped heads are to do with the engine being run with the fault not being cured.
Posted on Jan 13, 2010
Egr cooler leaking,very coomon on l200 with bubbles in expansion tank.
Posted on May 29, 2010
I had the same problem with my 04 4work , flushed and replaced thermo and water pump , now runs fine .
Posted on Mar 27, 2009
It seems these vehicles are very prone to overheating. I have the same problem, boiling up and emptying the radiator its OK normal running but get upto 70mph and temp goes sky high.
I have just fitted a brand new cylinder head and gasket 3 weeks ago but the problem has re-occured. Radiator seems clear, have removed thermostat and still it does it, water seams to be circulating so dont think its water pump.HAS ANY BODY SOLVED IT YET
HELP PLEASE firstname.lastname@example.org
Posted on Aug 03, 2012
Take the expansion pipe off and watch for water coming out. if it spurts out in regular bursts its one of the cylinders pressurising the water system.you can work out which cylinder is at fault by taking one glow plug out at a time and running engine till you find the one that dont spurt.if you are on a budget you could put some block sealer in the rad and run it for a few hours with the glow plug out and injector feed pipe loose.this will force the solution into the hole that the compression was coming thru.....
Posted on Jan 13, 2010
I Have 2005 Warrior l200 it started overheating pulled it down found gasket to be problem which was causing bubbling in expantion tank
Posted on Jun 13, 2009
My l200 was overheating above 2500 rev's I changed out the radiatir today and problem sorted, not too exspensive and changed in less than a n hour.
Posted on Apr 08, 2009
One solution I read was to replace water pump given that impeller could alternately slip / bind on shaft due to heating
Posted on Sep 15, 2010
"these engines are weak and should not be turbocharged or intercooled"
please check my videos on youtube:
the problem that everyone is talking about is the same at 4d56 and 4d68 engines and have a simple solution.
i run a 4d56 at full rpm with 1.5bar of pressure on turbo vegetable oil, in freeway and all terrain no problem at moment, i have a galant diesel with 4d68t that is similar with the 4d56 , and no problems in that part. all my cars have more than150000 km made. i sold either a old car mine a space wagon (expo) with same engine, 310000km made.
more information please contact- me.
email@example.com and check my youtube page.
Posted on Dec 10, 2009
It is a cracked cylinder head, these engines are weak and should not be turbocharged or intercooled. My brothers L200 has had new block etc cost £1200 for a rebuild. Its now common knowledge that this is a major problem with the L200 range.
Posted on Mar 27, 2009
I have a Shogun Sport 2002 fitted with a 4D56T 2.5tdi engine.
I had to fit a brand new cylinder head to this vehicle because it cracked just on 90k miles [i have had it from new and I am a motor vehicle engineer]. When I replaced it I also removed and flushed the radiator - replaced crankshaft pully, timing belts, water pump - removed egr valve and blanked it off. Flushed heater matrix and engine block.
The head came complete with new injectors, valves, rockershaft etc.
I ran it till hot then flushed the oil - replaced oil & filter - removed water from cooling system and added a coolant mixture with a conditioner [Forte].
All new drive belts and Sport runs sweet.
Must be a design flaw in the head that causes this to crack and always around the 90 / 100k miles.
Posted on Sep 14, 2014
My 06 warrior has now blown 3 head gaskets ! i have just found out from a mate in main dealer that they now remap ecu to make engine run cooler . there is now a new type of gasket out thats the third kind i have fitted . i have also fitted a new copper & brass double cored rad as my original one was nearly blocked with milky sludge .
Posted on Jul 22, 2010
I have also a Mitsubishi L200 1999 2.5 turbo diesel. I had the same problem. Your head gasket is blown and you MUST try and get it fixed. Check the oil content at all times. The reason why I say that is because your water must be mixing with the oil. During repairs, check if the head is warped.
Posted on May 10, 2009
I have a 56 plate l200 Animal, at 56000 miles i started having over heating problems.The thermostat would rise into the red and them blow water out of the header tank. After many atemps to find what the probem was they finally found that there was a problem with the head. The head was replaced, but after another 1000 miles it happend again, they then relaced the short motor, radiator and the rest of the cooling system yet it happend again. Mitsubishi replaced the head gasket and since them touch wood it has been running OK. All i can say is that god the warrenty coverd everything, the car is due to go in Sept, cant wait to see the back of it.
Posted on Jul 03, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
May 04, 2014 | Cars & Trucks
Mar 18, 2013 | Volkswagen Polo Cars & Trucks
May 01, 2012 | 2002 Subaru Legacy
Feb 18, 2011 | 2004 Volkswagen Jetta
Oct 25, 2010 | Mitsubishi Pickup Cars & Trucks
Dec 23, 2009 | 2001 Ford Taurus
Jan 01, 2009 | 2002 Mitsubishi Lancer
Dec 03, 2008 | 1997 Jaguar XK8
22,659 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: