Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Sep 23, 2012

Location of park assist sensors 2010 edge - Edge Ford Cars & Trucks

2 Related Answers

raygin

Raygin

  • 322 Answers
  • Posted on Jan 20, 2010

SOURCE: Bad parking assist sensor.....is there a fuse for the park assist?

This is a shared fuse, if you remove it you will lose other services. As your reverse aid sounds all the time it has a probable fault in the module or wiring. The module is located in the left hand side lower boot. To disable - pull the plugs from the module until you get it checked out. These modules often suffer from dampness in the boot as it is prone to leaking. sometimes just removing and refitting the plugs and then spraying with a water dissipating spray (WD 40) often brings them back to life once they have dried out.
hope this helps - good luck.

Ad

Anonymous

  • 8197 Answers
  • Posted on Nov 08, 2010

SOURCE: need to how location of

The fuse fo the parking assist is #35. You can get the owners manual on the link below page 245 shows the fuse layout.

http://www.motorcraftservice.com/pubs/content/~WOAEDG/~MUS~LEN/40/10edgog3e.pdf

Good Luck

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
3answers

2013 Ford Edge, none of the rear parking sensors are clicking when in reverse, does that mean the module is bad? Where is the module located? Thank you

No that doesn't mean the module is bad , taking to a qualified repair shop that has a scan tool that can check for codes in the park assist module is what you should do. Before replacing parts that may or may not fix the problem .
0helpful
2answers

Can't figure out how to turn off the Park Assist beeper on my 2005 Ford Expedition Eddie Bauer. It drives us nuts when we are trying to back up with our camper in tow.

Parking Aid Navigator The parking aid system consists of the following:
  • one radar sensor (located in the center of the rear bumper)
  • two ultrasonic parking aid sensors (located on the left and right side of the rear bumper)
  • parking aid module (located behind the LH C-pillar trim panel)
  • parking aid speaker-audible warning tone (located in the parking aid module)
Expedition The parking aid system consists of the following:
  • four ultrasonic parking aid sensors (located in the rear bumper)
  • parking aid module (located behind the LH C-pillar trim panel)
  • parking aid speaker-audible warning tone (located on the parking aid module)
  • reverse gear select input (to the parking aid module from the reverse lamp circuit)
  • The parking aid system is enabled when the ignition switch is in the RUN position and REVERSE is selected. The system can be disabled through the message center RESET switch located in the instrument cluster. The parking aid menu is displayed until the transmission is taken out of REVERSE. While the menu is displayed, pressing the message center RESET switch changes the parking aid system status to OFF.
1helpful
1answer

Reset factory mode on settings for 2010 Chevy Tahoe?

check fuses and relays --for the tpi if all tires are up on pressure and on screen is showing a dash for one of them than that tps is faulty they fail like any other sensor have the trouble code read for problem most auto stores offer this service for free after code read you can ask them to clear/erase which will reset settings / computer --with oark assist if dirt, debris, some one hitting rear bumper, towing/carrier mounted will shut off park assist
1helpful
1answer

HOW DO YOU TEST THE PARK ASSIST ON A 2007 FORD EDGE

Check with a diagnostic scan tool for module fault codes and sensor fault codes. If nothing comes back complete electrical circuit prove out.
0helpful
1answer

Where is the wiper relay located on 2007 For Edge?

The wiper relay is integral .The following components are integrated in the wiper motors:
  • Wiper motor module
  • HI/LO speed relay
  • Run/park relay
  • Washer pump relay
  • Park sense (Hall-effect sensor
  • What is the problem ?
0helpful
1answer

Parking brake don't hold on 2010 ford edge

under factory warr bring it to them
2helpful
1answer

Need to how location of fuse for parking assist on 2010 ford edge

The fuse fo the parking assist is #35. You can get the owners manual on the link below page 245 shows the fuse layout.

http://www.motorcraftservice.com/pubs/content/~WOAEDG/~MUS~LEN/40/10edgog3e.pdf

Good Luck
Not finding what you are looking for?

535 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...