Trying to find location of ABS relay on 2000 Chevy Suburban
SOURCE: 2000 ABS relay location
Unfortunately the ABS relay is built into the EBCM. Electronic Brake Control Module. That is located on the frame rail, left side of vehicle and sits on top of the pump. Both parts are likely to be replaced together as getting the module off the pump can be difficult. I recommend a repair facility do this job but it can be done at home. You will likely need to take loose metal brake lines and that can be quite a task also.
Are you getting a code for the relay / EBCM?
Good luck
Please rate my answers if they helped.
Brett
SOURCE: Where is the location of the fuel filter in a 2000
Fuel filter—4.8L, 5.3L and 6.0L engines—2000–01 vehicles
It will be on your frame rail.
If you have fuel injection, it'll be in your gas tank part of the fuel pump module.
SOURCE: 2000 impala crash sensor location?
You have more than one. Which one needs replacing and why?
SOURCE: 2003 Chevy Malibou RU872 resistor location blower switch relay
For location and replacement of the BMR. Remove the shroud below the glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the power harness - - you'll need this extra room to work with. 2 more screws, same size, 7/32, 6.5, 7or 8mm on some, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage/dealer - up to $400.
SOURCE: where is fuel pump relay on 1989 chevy suburban 1500
passengers side firewall behind plastic cover thats about 12 inches long with a bump in the middle,where the battery cables hook together ,there should be 2 relays there and i think its the one closest to the drivers side
6,852 views
Usually answered in minutes!
×