Have engine light on in my dakota 1998 i used the pocket scan and get the code P0123 thas what i need help for fix the problem
Throttle position sensor (tps) voltage high po123 look under hood for emission routing and devices ,it should be on back of motor near throttle cable ,remove 2 screws and un plug, install in reverse. good luck ,hope this helps.
SOURCE: i have a 1998 dodge dakota auto-transmission no 2nd or 3rd or o.d.
Now that helps....Below is a picture for you as well as a desciption with possible causes of the code you recieved. I hope this helps and goos luck....
SOURCE: What does a Dodge Dakota Fault Code P35FE means or signifies
Generally, PCM (Powertrain Control Module) fault codes are showed as Pxxxx. Codes are displayed on the odometer.
On some cars, the codes will read out if the engine light is on - all you have to do is put the key into the RUN position.
Normally, to get codes, you put the key on OFF and then rapidly do OFF-ON-OFF-ON-OFF-ON (on some cars you have to do four or five, not three, OFF-ON cycles). To know about means description, visit OBD Fault Codes.
Hope this helps; also keep in mind that your feedback is important and I'll appreciate
your time and consideration if you leave some testimonial comment about
this answer.
Thank you for using Fixya, and have a nice day.
Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.
680 views
Usually answered in minutes!
×