SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
SOURCE: Power Door Lock Problem
The last post by maddog1321 was exactly what I had with my right rear door. The electric locks would not lock and unlock, and you almost couldn't do it manually without my feeling I was about to break something. I took the door panel off, oiled everything and got no relief. Finally, I saw the above post and drilled out the aft-most pop-rivet. THE WINDOW WORKED PERFECTLY! I didn't drill out the forward (closest to the handle) pop-rivet because I wanted to do one at a time so the solenoid would not fall out of place. I then put a new pop-rivet in place of the one I drilled out. I then reinstalled everything and the locks work like new.
SOURCE: passenger power window does not work 2002 Silverado HD Ext Cab
REMOVE THE DOOR PANEL TO GET TO THE WINDOW MOTOR. REMOVE THE CONNECTOR ON THE MOTOR. LOOP A TEST LIGHT FROM BOTH TERMINALS. WITH THE KEY ON AND BOTH SWITCHES IN PLACE, CHECK TO OPERATION OF THE SWITCHES. IF THE LIGHT COMES ON IN BOTH DIRECTION THE WINDOW MOTOR IS BAD.
THERE IS A CIRCUIT BREAKER BUILT INTO THE WINDOW MOTOR. SOMETIME HITTING THE MOTOR WITH MAKE THE CIRCUIT BREAKER RESET BUT THE MOTOR WONT LAST LONG DOING THAT.
ALSO TRY PULLING DOWN ON THE WINDOW WHILE TRYING THE SWITCHES. THE WINDOW COULD JUST BE STUCK. THIS HAPPENED TO ME.
Testimonial: "Thanks, BB1BUD. I ended up replacing the entire regulator with a part I ordered online. So far so good."
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
SOURCE: 2005 Chevy Colorado, drivers window, and door
check the control on the door some times is loos also the fuse on that door.
180 views
Usually answered in minutes!
×