Disc 2 Alpine radio ask for code ,Do have code but radio does not allow to enter code

notify me/be dealer with vin and proof of ownership

https://www.carstereocode.com/unlock.php?id=24

I just had this happen today when I jump started my car due to leaving my head lights on. Call the honda dealership you got your car from, or if you bought it privately just call a honda dealership. They will tell you to press and hold the pre-set buttons 2 & 6 and it will give you a number, they will type it into their computer and they will be able to give you the code. You have to use the pre-set buttons on the radio to enter the code. That will fix the problem... If you already entered to many wrong codes it will not allow you to enter anymore... You will have to either wait an hour and then it will reset again and let you enter the code or you can disconnect the battery for 5-10 mins, reconnect it and then the radio will reset and ask you for the code again. Good luck guys!

The following instructions will allow you to reset any GM (General Motors), Cadillac, Oldsmobile, Buick, Pontiac theft lock radio.

Requirements: the theft lock radio must be in "LOC" mode.

Procedure:
1. Turn the ignition ON (The radio should display "LOC")
2. Hold down the Radio Presets 2 and 3 buttons for six seconds
3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.
4. Press the AM/FM button
5. The radio display changes to another three-digit number. Write this number to the right of the first one.
6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05
7. Call 1-800-537-5140
8. Press 1 then # (pound). You'll hear "Invalid Code, try again"
9. Press 139010 or 106010 or 206010 or 202107 then # (pound). You will be asked to enter your four or six digit code followed by *
10. Enter the number from STEP 6 then *
11. Listen to the four-digit number and write it down. It will be repeated twice
12. Turn the ignition ON (The radio displays LOC)
13. Use the MN and HR buttons to enter the code from STEP 11
14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.

If you fail to enter the correct code eight times, the radio goes into INOP mode. You have to wait an hour with the ignition on before the radio returns to LOC mode.

Hope this helps; keep in touch.

These older Alpine radios require specialist advice

Ask here for free advice

www.ukbookshelf.co.uk

A Common place for the code is normally in the glove box or behind the radio itself, which probably means removing the radio, sometimes you can pop your head under the dash with a mirror and light though.
If you enter the code wrong a few times and it won't allow you to reenter the code, you can disconnect the Negative battery cable for a few minutes and it should let you retry.

Hi Cag. You can call your local BMW dealer and ask for the parts department. Alpine,and Blaupunkt,were the most common radio makers. The parts guys have a software program they can enter your radio serial number and retrieve a code.

Try this web site radio codes
They will charge you $4.95 and will also give you the procedure on how to enter the code. Hope this helps.

Lefty64

TURN ON THE IGNITION FOR APPROXIMATELY 2 HOURS AND CODE WAIT WILL DISAPEAR AND YOU WILL GET:

CODE_ _ _ _ _ _