2000 Acura TL Logo

Related Topics:

Mike Mathias Posted on Oct 09, 2012

2000 acura tl battery light does not come on when ignition key turned to on postion battery not chargeing

No battery light on dash cluster when key turned to on postion battery not charging checked all fuses under hood @in dash

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 29 Answers
  • Posted on Oct 09, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Oct 08, 2012
Answers
29
Questions
0
Helped
8718
Points
84

Its probly ur alternator. u can check it by starting your car then taking off positive cable when its running. if it stalls its the alternator not charging

5 Related Answers

Anonymous

  • 25 Answers
  • Posted on Dec 31, 2008

SOURCE: Check Engine light on Acura TL 3.2 1999

You can turn off the Check Engine light by either disconnecting the battery or by using a code reader to clear the codes. However, if the problem still exists it will come right back on. Instead you should get the code read, find out what the problem is, and fix it. Your local autozone or checker auto parts store will read them for free.

Ad

Anonymous

  • 41 Answers
  • Posted on Mar 19, 2009

SOURCE: starter replacement on acura 2000 TL 3.2

This starter can be changed without disassembling the top of the engine on the 2.5 with automatic transmission. You will need a 10mm, 14 mm, 17mm, and a 9mm wrench. First with any electrical repair disconnect the battery at the negative terminal. The starter is on the driver's side close to the firewall below the intake manifold. Remove the transmission dip stick so you don't ruin it, then look and study the starter itself. You will notice the starter drive housing with a top and bottom bolt. The top bolt is a 14mm and the bottom a 17mm, loosen both a half turn. Remove the top 14mm bolt first, then the bottom 17mm, this will allow you to pull the starter out of the bell housing. With some angling and no brackets holding the back of the starter you should be able to pull it out enough to disconnect the positive wire and 9mm nut from the soleniod. Disconnect the starter ignition small wire by pulling it off it's connector. Now just pull it out of the engine and fender void and you've got it, saving about a hundred and fifty dollars of labor. Take it to the parts house and match it up with a well made remanufactured or new starter. Reverse the proceedure, hook up the battery.

Anonymous

  • 1 Answer
  • Posted on Mar 30, 2009

SOURCE: How do you reset the check engine light on an Acura TL 1999

i dont know how else to do it other than with a diagnostic tester. i think that may be the only way.

Anonymous

  • 1 Answer
  • Posted on Apr 21, 2009

SOURCE: no radio and cigarette lighter on my 1999 acura tl

Fuse box is on drivers side kick panel under dash.

It blends in very well due to being carpeted.

Anonymous

  • 811 Answers
  • Posted on Sep 27, 2009

SOURCE: Please help....I have a 2002 Acura TL Type S. The

check under hood for other fuses or relays

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 Acura TL. Battery & starter replaced. This morning it would not start, key fob not work. when key turned in ignition, nothing. No lights, radio, click. completely dead. What could the problem be?

Battery cables ? Hard to say for sure Cassandra ,Would need to do so electrical testing ! Do you own a DVOM - digital volt ohm meter ? There are videos on youtube showing how to do basic automotive electrical testing ! First one I would do is voltage drop testing the starting circuit , charging system ! Voltage Drop Test
0helpful
1answer
1helpful
3answers

99 acura tl wont start. Replaced Nuetral safety switch, but still won't start. Lights work on dash, and head lights are bright. Any suggestions? Thanks.

Have you done the testing at the starter wiring your not receiving hot to the solenoid circuit on the starter when the key is turned over? Place a test light on the connector for solenoid hot and have some one turn the key if it lights check for constant voltage on the large wire connection from the battery to the starter. If that's all working your starter is bad.
1helpful
2answers

Acura Tl 2005 won't start

This vehicle is equipped with a chipped ignition system.On your dash warning lights,when turn key into on position you'll notice a yellow key symbal, it should flash then go out. If it flashes then goes to solid on, it means the system does not recognize signal from key. This can be because of wrong key(original valet key will not start car) or key for whatever reason has been deprogrammed. Which can only be done by dealership unfortunately. If system is working(light does go out) then you need to look at possible brake switch sensor,park/neutral safety switch on shifter, and for signal at started when key turned to start position
0helpful
1answer

96' 3.2 Acura TL dies while driving now won't

i have posted this solution before, I will give you the short version. On the steering column, under the left side of the cowling, on the opposite side directly across from where the key goes in the ignition,... there is a wire loom screwed to that end with 2 screws, remove this and clean the inside of both sides CAREFULLY, dont break anything. expensive dealer part! just scrape it lightly and wipe a little, carefully re assemble, dont bend it, dont screw it back in too tight, you cant make it go together any closer than it will. This solution solves a number of odd problems attributed to ACURA quitting , battery not charging, lights flickering turn signals not working, a lot of things, so i think everyone should do this to there ACURA, and its EASY!
0helpful
1answer

Need radio code for 2000 acura tl

You need to get the serial number off the sticker attached to the radio. It will require pulling apart your dash. Call an Acura dealership with that serial number and they should be able to provide you the code. Or you can take it directly to the dealer but you will be charged labor.
0helpful
1answer

My 96 acura tl 2.5 the numbers in the dash dont work any more what could be wrong?

you may have a bad cluster,remove the cluster and check the connections going to cluster in the back, also make sure all your fuses are good,if everything looks good then i would replace the cluster.
1helpful
1answer

Having trouble sarting a 98 Acura TL when i turn the key all i get is dash board light flickering. My neighbor arched the battery terminals and got large sparks. We asume the battery is good but i am not...

thry new battery or know good one sounds like the some cells on that battery are collaps donat start the car with the carger on high this will make the voltage regulator crazy and the light will flicker
0helpful
1answer

What is the trick to turn off de mantenance light

I believe you have to turn the key to the on postion while at the same time holf down the reset button where your gauges are. Your going to have to hold it for a few seconds, then if I am right you will see a couple of little bars where your milage is suppost to be pop up and then one by one go away. Once all of the litttle bars have gone away your maintenance required light should go off.
Not finding what you are looking for?

411 views

Ask a Question

Usually answered in minutes!

Top Acura Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...