Question about 1999 Dodge Neon

Open Question

How to replace fuel filler neck on 99 dodge neon

Got new filler neck replacement but had no steel replacement lines that are on the outside of current neck that needs replaced. What is the small line on outside of filler neck line called?

Posted by Anonymous on

Ad

5 Suggested Answers

Anonymous

  • 1392 Answers

SOURCE: How to change dodge neon fuel filler neck

unbolt the neck from the body of the car. Drop the gas tank enough to get the neck out. Reinstall.

Posted on Mar 10, 2009

Ad

chryslerguy

  • 323 Answers

SOURCE: we have a 2002 dodge durango that we bought used

A small evap leak is usually a vapor line with a small crack in it or fuel cap seal. The vapor lines usually crack where they meet a plastic or metal line attachment. Where the line has to swell a bit to fit the other line is where the small crack occurs. You can feel each line at these points and find the crack. It will feel smooth all the way around and then a rough spot. Check the lines going to the service port under the hood and then follow them back to the canister looking closely at each connection. If you don't find anything replace the fuel cap and retest. It is rarely any of the other system parts you mentioned. If it goes undetected long enough a new code will come up as P0442 medium evap leak, meaning the crack has become bigger and possibly easier to find. It is strictly emissions and will have no effect on the way the vehicle runs.

Posted on May 18, 2009

Ad

Anonymous

  • 5 Answers

SOURCE: Is a 2000 Dodge Grand Caravan fuel filler neck usable in a 1999?

yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse

Posted on Jun 25, 2009

Anonymous

  • 51 Answers

SOURCE: how to replace ac condensor on 1995 dodge neon

un hook the lines, remove the radiator, remove the ac lines, remove the condenser supports, then it is out. i would not recommend this to a novice mechanic. you need a vaccume pump to refill the r134a.

Posted on Aug 08, 2009

localwonder

Michael Masters

  • 6784 Answers

SOURCE: 2002 Dodge Neon Fuel Pump Replacement

HI.Your fuel pump is an integrated part of the pump module, which also contains the fuel reservoir, level sensor, inlet strainer and fuel pressure regulator. The inlet strainer, fuel pressure regulator and level sensor are the only serviceable items. If the fuel pump requires service, replace the entire fuel pump module.

There is no access panel. You will need to, slightly, drop the fuel tank, in order to extract the module for replacement. This module it mounted on-top of the tank. the module is inserted into the tank.

Posted on Dec 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge grand caravan 2005 filler neck replacement


1)Block front wheels.
2)Jack up the left rear tire off of the ground.
3)Put blocks up under the frame.
4)Take off the left rear tire.
5)Take out the plastic liner in the fender well that covers the fuel filler neck.
6)Loosen up the hose clamps on the rubber fuel filler hoses. (at the neck side); once the clamps are off plan on buying new ones. This next part of the job is VERY IMPORTANT! use a flat screwdriver and pry 360 degrees all around the rubber filler neck hoses. (they get kinda glued on from being on there so long). Next Get some PB Blaster lube or WD-40 (it has to have the small red squirt hose) and spray the lube up in between the hoses while you pry around. the more you do this the easyer it will be to pull the metal filler neck pipe out.
7)Now its time to take out the 4 bolts that hold the pipe on.
Use a 10mm socket and extension to take out 4 bolts up top behind the fuel filler door.
8)Pull the filler neck out and put everything back together the way it came apart and your done!

Aug 26, 2016 | 2005 Dodge Grand Caravan

1 Answer

How to replace fuel tank filler tube?


Brother John, you've removed as much as you can for access to the filler. Remove the hose clamps/bands that secure the fill tube and vent tube and then remove the screws around the gas cap that secure the fill tube to the body. With the gas cap off, go below and pull the hose and filler neck down and work the hoses lose with a pair of channel lock pliers and sticking a screwdriver between the metal tube and hose to break the seal. Put on the new filler neck and stick it back up in the body and put the screws back in. THEN put the hose clamps back up and tighten them, put the gas cap back on and your done.

Nov 30, 2014 | 2000 GMC Jimmy

1 Answer

How do i remove the hoses from my gas filler neck


I do not have experience with a Durango. I have experience with a Chevrolet. The hose on the filler line was large diameter and very hard. It would not slip off. I had to empty the gas tank, cut the large hose, and remove the small hose. Then I had to jack up the car, and lower the gas tank to the ground to have room to work. From there is was simple to remove and install parts, install the gas tank, and tank up.

Nov 30, 2014 | Cars & Trucks

4 Answers

What would give out fuel smell ?


did you check to see if your gas cap is missing?

Jul 13, 2014 | 2000 Ford Taurus

1 Answer

How to replace the fuel tank filler pipe mercedes c200 kompressor


You can check to see if the hose clamps are tight on the filler neck and the breather hose ,i would also check the fuel filter under the car rear near tank for leak's as this can give the smell of fuel around the rear of the car . when you open the boot of the car do you smell fuel or is it only on the outside of your car????? hose clamps and fuel filter = outside of car. smell in side of trunk (boot ) fuel return line hose clamp might just need to be tightened up. you might have to remove the rear wheel and inner wheel cover to get to the Fuel tank filler to check the hose clamps.

Feb 12, 2018 | 2000 Mercedes-Benz C-Class

1 Answer

Replacing fuel pump


To replace the fuel pump you must remove the fuel tank form the car. You will need a floor jack and jack stands and then remove the steel straps that hold the tank in place and then the filler neck and drop down tank to access the fuel lines, disconnect the lines with the special tool kit and slowly drop the tank out.

Jun 17, 2012 | 1999 Saturn SL

2 Answers

WHEN I POUR GAS IN TANK IT WILL NOT GO IN TANK IT IN UP ON GROUND HOW DO I FIX THAT GAS LINE GOES TO TANK


most fords i have had have this problem the small vent hose gets a hole in it and gas won't go down, need new filler tube. u will have to lower gas tank and remove screws from filler neck around cap to change out , easier if tank is empty.

Mar 15, 2011 | 1993 Ford Econoline

1 Answer

Remove gas tank


HI, you will need to remove as much fuel as possible, then raise the van up and support it so there is enough room under the van to drop the tank out.
1) remove the fuel line from the fuel filter and the return line .
2) you will see a black EVAP canister by the fuel filter you will need to disconnect the lines from it. The remove the lines from the fuel tank that run from the canister.
3) Loosen the clamps on the fuel filler neck and pry the neck away from the tank. there will be a small vet line running to the filler neck this also needs to be removed.
4) you will need to support the tank and remove the 3 bolts holding the straps. then lower the tank down.

Sep 13, 2010 | 1999 Chevrolet Venture

1 Answer

Replacing fuel filler neck on 2000 Crown Vic


Good news, no the tank doesn't have to come down. However, there needs to be less than 3/4 tank. Jack it up and set on a jack stand, remove the wheel, four screws housing to pipe, filler pipe sensing hose from filler pipe, screw retaining the cap, four retaining screws from filler pipe, screw from filler pipe retainer, slide into the tank until it can be rotated and pulled out through the fender. lube the tank grommet with clean oil and reverse the removal for install.

Aug 21, 2009 | 1996 Ford Crown Victoria

Not finding what you are looking for?
1999 Dodge Neon Logo

Related Topics:

411 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...