2005 GMC Sierra Logo

Related Topics:

A
Anonymous Posted on Oct 13, 2012

How do you replace door speakers on 2006 gmc sierra?

5 Related Answers

Anonymous

  • 1990 Answers
  • Posted on Jan 10, 2009

SOURCE: i need 2 know what size speakers go in the front doors, 2002 gmc.

Those are 5 Inch Speakers and Tweeters I do Believe.

Ad

Anonymous

  • 56 Answers
  • Posted on Mar 10, 2009

SOURCE: 1989 GMC Sierra truck doors loose

Hey there.You can purchase a door pin and bushing repair kit to tighten up the hinge area,requires removing the door to replace.If the hinge area is worn to badly,the brass bushings willnot last.Also your window crank handle is held on by a C-clip behind the handle in between the plastic shim and the handle which requires a special tool to remove or a small screwdriver to get the clip off.It is hard to see.The shaft that the handle is on are known to wear also and if thats the case you will need to have the window regulator replaced.Hope this helps.John.

Anonymous

  • 5 Answers
  • Posted on Jan 12, 2010

SOURCE: replace door speaker 2001 gmc sierra

pull your door panel off and unscrew the speaker and disconnect the connectors to speaker 

Anonymous

  • 19 Answers
  • Posted on Jan 25, 2010

SOURCE: 2006 GMC Sierra Denali,wont turn over, battery

iF YOU HAVE NO 'CLICKING' OR ANYTHING THAT INDICATES A DEAD BATTERY - NO DASH LIGHTS ETC, THEN LOOK AT YOUR BATTERY FIRST, TRY TO JUMP IT. THISE ARE TOUGH TO JUMO AND TAKE ALOT OF JUICE TO START YOUR VOLT METER NEEDS TO READ OVER 13 VOLTS, DO NOT CONNECT TO BATTERY FOR BEST RESULTS, CONNET TO ENGINE, NEXT TO THE ALTERNATOR IS A GREAT SPOT, AND THE RED BLOCK THAT IS UNDER THE MASTER BRAKE CYCLINDER (YOU'LL SEE IT WHEN YOUR STANDING AT THE FRONT OF THE TRUCK AND LOOK TO THE RIGHT BETWEEN THE BATTERY AND THE ENGINE)

IF YOU CAN GET ANY JUICE TO THE CAR TO EVEN MAKE THE LIGHTS COME ON AND GET THE INSTUMENTS TO READ OUT, ETC BY USING JUMPER CABLES, THEN MAKE SURE YOU CAN GET JUICE, ALSO MAKE SURE THAT EVERYTHING IS OFF, ROLL DOWN THE DRIVERS WINDOW - OF COURSE YOULL NEED TO MAKE SURE THAT IF THE VEHICLE DOESNT START TO LEAVE THE JUMPER CABLES ON LONG ENOUGHT TO PUT IT BACK UP, AND CLOSE THE DOOR, LEAVING ANY ACCESORIES ON LIKE THE AC, RADIO, ETC JUST MAKES JUMPING THIS 10x HARDER, YOU MIGHT EVEN NEED 2 CARS AND 2 JUMPER CABLE, I THINK THE BEAST NEEDS SOMETHING LIKE 400 AMP TO CRANK OVER, IT'S ON THE BATTERY. ANYWAYS THE REASON WHY YOUR PUTTING THE WINDOW DOWN IS SO YOU DONT LEAVE THE DOOR OPEN AND WASTE JUICE, LEAVE THE KEY IN, BUT JUST PUL IT OUT ENOUGH SO IT'S NOT CHIMING. HAVE THE PERSON WHO IS JUMPING YOU SLOWLY REV THERE ENGINE TO SEND MORE JUCIE TO YOU. I HAVE THE SAME TRUCK AND HAD THIS HAPPENA MILLION TIMES. I FINALLY BOUGHT A JUMPER BOX FOR $50 AND IT SAVED ME ALOT OF HEADACHES. MY PROBLEM WAS I HAD A PROBLEM IN THE ELECTRICAL THAT LEFT A DRAW OPEN - THE IDEA THAT WAS POSTED ABOUT BYPASSING RIGHT TO THE STARTER IS A GREAT ONE, BU IF YOU NOT SURE WHAT YOUR DOING IT'S NOT REALLY THE 1ST AVE I WOULD TAKE, IT WILL JUMP THE TRUCK AND TURN IT OVER (UNLESS THERE IS ANOTHER PROBLEM) BUT WHAT ABOUT THE NEXT TIME? IF YOU PUT THE KEY IN AND GET A READING OF 13 +/- VOLTS ON THE DASH GAUGE THEN YOUR PROBLEM IS MOST LIKELY YOUR SOLINOID (SP) IT'S ABOUT A $60 PART AND EASY TO PUT IN, INVEST THE $$ TO BUY A CHILTONS OF EVEN BETTER A GM SERVICE MANUAL FOR THE TRUCK. WHEN YOU DO GET IT STARTED THE GAUGE SHOULD START TO RISE AND READ 14.5 +/- VOLT CONSISTANTLY, BUT IF YOU GO TO AUTO ZONE THEY WILL 'LOAD TEST' YOUR TRUCK FOR FREE. IF YOU STILL HAVE THE ORIGINAL BATTERY ITS TIME FOR A NEW ONE - AND DONT CHEAP OUT ON THE CHEAPEST ONE, SPEND THE MONEY FOR A GOOD BRAND OF BATTERY, SOMETHING THAT CAN HANDLE THE BEAST, 600 COLD CRANKING AMOS IS WHAT I THINK THE RATING FROM GM IS. IT WILL SAVE YOU A LOT IN THE LONG RUN. AUTO ZONE WILL HOOK UP A TESTER AND LET YOU KNOW IF YOUR BATTERY IS NO GOOD OR YOUR ALT IS BAD, ETC. BUT IT PRETTY MUCH ALLL STARTS WITH THE BATTERY.

THE ONLY OTHER THING IS THAT YOUR VEHICLE MAY BE IN LOCK DOWN IF YOU HAVE A KEY THAT IS WORN REALLY BAD AND ALOT OF MILES YOU MAY NEED TO REPLACE THE IGNITION CYCLINDER - ANOTHER $60.00 FROM THE PARTS COUNTER, AND THEN YOU NEED TO HAVE A BLACKSMITH CODE THE CYCLINDER, $35.00. HOPE I'VE HELPED

Anonymous

  • 119 Answers
  • Posted on Feb 14, 2010

SOURCE: 2006 GMC SIERRA door speakers only work

under warrantee take it to the dealer and say FIX THIS

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Replace speakers in the door

By far the easiest way to do this is to go to Crutchfield.com. They will take your vehicle information, tell you what speakers will fit in you door(s), provide you with detailed instructions on the procedure to remove the old speakers, give you any adapters or spacers necessary for the new speakers. It doesn't get any easier than that.
0helpful
1answer

Check pdm

Try checking the connector on the back of the switch assembly on driver side door. If it's not connected properly it will not provide power to any of the window switches.
1helpful
1answer

The front door speakers are not working, but from time to time they come on for a brief moment. also, the door chime only works if the front door speakers are working. weirdest thing i've ever seen....

The door chime is played over the speaker. I had the same issue the speaker was junk. The circuit resistance was correct but no tunes. Replaced the speaker with one from the junk yard and sounds great all the time.
1helpful
1answer

How to replace 2006 GMC Sierra drivers side door speaker?

you have to dismount all cover side door and it is easy to replace
0helpful
1answer
1helpful
1answer

Replace door speaker 2001 gmc sierra

pull your door panel off and unscrew the speaker and disconnect the connectors to speaker 
0helpful
1answer

Can I pull the grill off the speakers to put them

NO' YOU DONT NEED TO REMOVE THE ENTIRE DOOR PANEL, TO REPLACE SPEAKERS CONNECT WIRING CONNECTOR TO SPEAKER FIT SPEAKER BACK IN GRILLE AND REPLACE RETAINING SCREWS.
0helpful
2answers

I need 2 know what size speakers go in the front doors, 2002 gmc.

Those are 5 Inch Speakers and Tweeters I do Believe.
Not finding what you are looking for?

165 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...