Where is the fuse box in a 1992 Chevrolet S-10 pickup?

Question edited for clarity.
Question moved to category.

Fuse 9 - PCMNCM Battery, ABS Battery, Fuel Pump (LN2)

A fuel pump wiring short is the most likely. Look for wires rubbing through near where the wires enter the tank.

Chevrolet S-10 (1996) - fuse box diagram - Auto Genius

https://www.autogenius.info > chevrolet-s-10-1996-fuse...
Dec 31, 2017 - Chevrolet S-10 (1996) - fuse box diagram. Year of production: 1996. Instrument panel. The fuse block is in the instrument panel on the driver's ...

One these website you find fuse box diagram, description and location for Chevrolet S-10 (1997)

Chevrolet 10 1997 fuse box diagram Auto Genius

Chevrolet 10 1997 fuse box diagram

Hi!!

Remove the fuse box cover and look inside of it, it has a layout of the fuses names and locations.

Don't forget to rate this post!!

Flashers are generally located either under the dash (they hide them behind the horizontal panel) under the hood in the fuse box.

Also, relays can be hidden under the hood or in the fuse box.

The interior fuse box is where the 'turn signal' fuse is located.

Circuit Protection Fuses Underhood Fuse Block (Base)





Underhood Fuse Block (Except Base)







I/P Fuse Block

Here is a link for your to get the manual to your S10.
Thank you for using fixya and you should get your answer in your new manual.
http://www.ownersmanualsource.com/chevrolet/chevrolet-s-10-owners-manuals/

open the drivers door and look at the corner of the dashboard. a snap on lid you will see that is the fuse box

hello, should be attached to the fuse box on the bottom, it is round and plugs in to the fuse box some are on top some on the bottom. also blinker relay is there also.

Do any of these show what you need?
If not Autozone.com has online manuals (source of these pictures) and you can get your own log in and view them directly. You will need to input your vehicle and a few other items (VIN is not required) and create your account. Good luck.

on 1992 s10 remove the heater outlets and duck from under instrument panel. Remove air distribution model assembly,heater and seal. Disconnect neg batt cable. Drain eng coolant. Remove hoses at core. Remove rear case screws. Remove heater core from case.

try in the glove box area. may need to remove it too see the cover for heater core.