92 chevy pu have no lights in the rear of truck , I have checked fuse, bulb and bulb housing no power
There's a switch on the brake pedal arm that controls the brake stop lights, that needs adjustment or replacement.
Hope this helps.
You will need the wiring diagrams to troubleshoot this, we do not have them here at fixya, sorry. They can be bought used here if you would like
SOURCE: rear brake lights don't work
you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok
SOURCE: 1998 chevy truck tail light
Somtimes the bulbs get a dead short in them even though they look OK. Install new bulbs or remove all bulbs on this circuit and reinstall one at a time to see if fuse pops. I had this problem with signal lights on 95 chevy 1500 and turned out the back up bulbs were on the same circuit. Bad back up bulb so once truck was in reverse it blew the fuse and then the signals did not work. Cheap enough to be worth a shot.
SOURCE: brake light on 2001 chevy blazer LT 2wd
When my blazer did this they had to replace part of the wiring harness in the steering wheel. It took forever for them to get the parts because we live in nowhereville, but once it was in it works again and no problems. I had to take it to the actual chevy dealer because none of the other places had a clue. good luck.
SOURCE: Tail lights don't work on 1998 Chevy Silverado.
check the wiring from the tailights back to the fuse panel, it sounds like an open connection. if i recall correctly check under the dash on the drivers side near the fuse panel for a bunch of wires in a bundle and look carefully for a wire or two that are cut/shorted/or seperated, you can also check under the drivers side kick panel by the hood release.
SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
1,239 views
Usually answered in minutes!
×