-
Contributor
24 Answers
- Posted on Jan 02, 2009
Re: I need to locate the 4 wheel drive control module on...
- Remove the IP trim bezel.
- Pull out the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly in order to disconnect the electrical connectors.
- Disconnect all the electrical connectors from the lamp switch, cargo lamp and 4WD shift buttons assembly.
- Remove the lamp switch, 4WD shift buttons, cargo lamp and air deflector louver assembly from the vehicle
- Remove the electrical harness retainer from the IP support beam.
- Disconnect the 2 electrical connectors from the transfer case shift control module.
- Move the electrical harness to the left side in order to make room to turn the transfer case shift control module.
- Rotate the transfer case shift control module about 45 degrees counter clockwise while pulling out at the same time until the module is approximately 90 degrees from the original position.
- Pull out the module from the vehicle
×