When you try to start the car it turns over like its gonna start but never does, it sat for 3 or 4 months when it first quit starting and my mom took out one of the injectors and put it right back in and it started and ran fine for 2 days except one time took a couple minutes to start and now it wont start again, can anyone help i really need this running so i can get to and from work.
A possible fuel pump pressure issue. You will need to have a garage check the fuel line pressure. The engine requires more fuel on cold start and a failing pump may not be able to cope with supply. This may also be apparent at high revs, but not as apparent as cold start.
SOURCE: code P0340 & P0344 car
These codes indicate a possible camshaft position sensor failure, however a defective crank sensor can set these codes as well, due to the fact that both sensors share some of the same circuitry. I would highly recommend a powertrain control module update first, reference TSB# 18-026-03 before any parts replacement. Your local Chrysler dealer can perform this update.
SOURCE: 1998 Chy. Sebring will just
Hi! I strongly suggest that you have a PCM (powertrain control module) reset. The PCM has connectivity on all electrical current that runs inside the car including the engine, transmission, accessories, etc. It's like a car's brain that when it's faulty everything else fails. If the PCM can't be resetted specially when it's heavily damaged. I suggest that you have it replaced to get rid of all the troubles. Hope this helps and thank you for using FixYa!
SOURCE: Cirrus Stalling With Check Engine Light On did not come on the first time it happened
Your problem sounds like it may be a Mass Air Flow sensor, when it does run bad disconnect the sensor, if the engine starts running ok the sensor is bad, this would be the most common reason for your problem and why it is only intermittent. As far as the overheat do you have a coolant leak?
SOURCE: 2002 chrysler sebring LXI coupe would not start 2
They have either left a wire to the starter unhooked or they have blown a fuse or fuselink
SOURCE: 98 concorde lxi runs great but when you turn it
ignition MODULE needs replacing on the distributor
258 views
Usually answered in minutes!
×