When i start my 2005 acura 3.2 tl in the morning, it makes a noise coming from th passanger side under the hood. Also, the steering makes a moaning sound when turned. The noise stops 10 minutes later and doesn't come back till next morning.
I have a 2006 Acura TL, and recently it makes noise when start and reverse then after I drove for a few minutes then the noise is gone.
That noise is 1 of your belts. there is 3 belts on it. and with the power steering noise I think it is your power steering belt needs to replaced or agjusted
SOURCE: I just bought my 2004 Acura TL 2 weeks ago. It
What you describe is consistant with a lifter not pumping up except at a little higher rpm, which would make sense. You have overhead cams, with hydrolic lifters. They pump up with oil. If you have one that is not fully "pumped", it will make a clicking noise when the camlobe moves it and it strikes the valve. This is not the only thing it could be...and maybe it is the tensioner, but if it is coming from the valve area....Also, your dealer should have a special stethescope so the mechanic can listen in spots, and move the pick-up to where the noise gets louder and make a better diagnosis.
Testimonial: "thanks so much for the quick response!"
SOURCE: How do I replace side view mirrors on a 05 Acura TL
replacement glass use wally have a plastic thing behind the glass so just prime out the old glass carefully with a screwdriver from the mount and it will pup out and the new glass just press it in place with your hands and you will hear a click and its in its place.simple as that.
SOURCE: passanger headlight bulb inop
disconnected the HID ignighter. used a T20 to remove bulb cover. pulled out bulb and installed new bulb. DO NOT TOUCH THE BULB WITH BARE HANDS!!!
SOURCE: 1996 Acura TL Heater blows cold air when stopped
the heater core could be clogged you might again check your coolant level just to be sure its full
SOURCE: ACURA TL 2007 HEAVY NOISE IN THE ENGINE FOR 4 5
There are two mechanical noises you will hear from an engine, lifter noise, wrist pin slap, and rod bearing noise. The only one that will go away, if at all, with engine warm-up, is lifter noise. All assuming of course, the noise is coming from the engine, and not any of the externally mounted accessories.
Have the oil changed, and continue to change every 2000-3000 miles with a good quality oil, maybe the lifter will clear itself. If it does, maintain the oil changes for the next few changes to assure it is cleaning out.
You might also try adding 1-2 pints Berrymen's Chemtool to the oil 200-300 miles before you plan to change the oil.
Testimonial: "THE ACURA TL 2007 USE HIDRAULIC LIFTERS? WHERE?"
3,904 views
Usually answered in minutes!
×