I have a 1999 Chevy Suburban 2500 that will not start when it gets hot, i let it run for about 20 minutes yesterday and it ran great sounded goof and turn it off and 5 minutes later it would not start but does turn over and tries to start, i changed the plugs the other day, there is no check engine light on, also in times past the truck has stalled at stop lights with the AC running only it would never stall with the AC off, also lately i can feel a hesitation after getting up around 55 MPH, changed the fuel filter already as well....please help
SOURCE: Chevrolet 2500 Not Running, May Be Fuel Filter Sensor
That
red wire is only for the fuel heater.will not cause a no start.try pumping
the primer pump on top of the fuel flter hsg. but first open the bleed
screw,which is black plastic also located on the top.this will eliminate any
trapped air that might have entered the fuel intake system.if the pump does
not get firmer and harder to push, then you have a leak in the fuel supply
lines or the ck valves in the fuel filter hsg or stuck open. Still no start
have it scanned to ck fuel pressure while cranking.it should be close to 5000
lbs
SOURCE: Check Engine light & slight hesitation
I had the exact same problem. The mechanic found a spark plug that was leaking on the back of the engine that was a pin to get to.
He replaced all plugs and wires and I no longer have this problem, so you may be onto something with the plug wire being loose.
SOURCE: engine stalls, check engine light, not fuel filter.
the white smoke as it stalls could be steam in the exhaust. This is caused by coolant leaking into cylinders from a leaking head gasket. You should check cylinder compression next with a compression tester.
SOURCE: 2002 Toyota Tundra Stalls
The throttle body needs cleaning. It has some carbon build up, and when the battery went dead the computer lost its learned values, one of which is base throttle position. Now its reset back to factory specs, not accounting for a dirty throttle body. Seen it a million times
SOURCE: Chevrolet 2500 Not Running, May Be Fuel Filter Sensor
if it dont have good compression it will not start check the comp and make sure there no water in oil if fuel pressure is low it will not pop the injector open try some starting fluid
253 views
Usually answered in minutes!
×