Do i need a new shifter cable? Still shifts gears but very stiff. If so, is there an aftermarket part or dealer only? What is the part called?
SOURCE: removal of gear shift knob
There are two types of shift knobs. One that unscrews and one that the lower trim of the shift knob separates from the knob using a trim stick. After separating the lower trim from the knob pull upward to release the knob from the shift lever. If a new shifter assembly is being installed, unscrew the original shift knob or separate the lower trim from the knob and pull up to remove the knob from the shift lever. Screw the knob onto the new shifter assembly's lever no more than 14 turns or install the lower trim onto the shift lever then push the knob onto the shift lever and install the lower trim piece onto the shift knob.
SOURCE: 94 dodge neon auto tranny
Hi,
Here is some possible reasons why your transmission is having those problems .
* The gear shift linkage is binding
* There is an internal problem in the transmission
* The throttle cable is broken or disconnected
* The vacuum modulator on the transmission is faulty or the vacuum line is damaged
* The electronic transmission control circuit may be faulty
SOURCE: I have a 99 intrepid with a broken shifter cable
Have you spoken to the dealer, especially someone in service about this? They may shine some light on it.
SOURCE: where is the shift solenoid located on a 2003 dodge neon sxt
the trans shift solenoid pack is bolted to the side of the trans closer to the radiator. it is rather large and there are three 10mm bolts holding it to the trans. it is under the input speed sensor and just under the spot where the cooler lines go into the trans.
SOURCE: 2005 dodge magnum gear shifter
its your transmission shifter assembly it cost 65$ for the part from dealership and 100$ dollars in labor i just had it done to mine
52 views
Usually answered in minutes!
×