Hi i had a 1994 ranger with the same problem everybody said change the coolent temp cencer so i did it didnt realy seem to help so then i thought and thought and i realized that mabey my starter is worn and doesnt have the whirl power to start it (even though the starter sounds fine doesnt mean its not worn) so i replaced it with a brand new one and it started every time real quick after no matter how cold and later on found out this is a common problem with the ranger. good luck hpoe this works for you
SOURCE: signal lights and brake lights stopped working
the multifunction switch (turn signal switch) is a major cuase of this. your high mount stop lamp wire is run through the switch.
SOURCE: 2001 ford ranger no brake lights
check fuses under the dash and in the engine compartment/ Please rate my response thank you very much
SOURCE: 2000 Ford Explorerer rough idle When cold
what codes are present? If it is lean codes P0171/P0174 problem is most likely the orings leaking between upper and lower intake manifold if this is a 4.0L
SOURCE: 87 ford ranger wont start without starting fluid
It sounds like you aren't getting fuel out of the cold start injector... remove the injector when engine is cold and switch on ignition... you should get a fine spray pattern for a few seconds... if not then there is probably a problem with the cold start circuit (Temp sensor fault), or the injector is faulty. pull electrical connectors one at a time and look for corrosion... Hope this helps...;-)
SOURCE: 2003 Ford Ranger hard to start when cold. must
you may just have a weak battery, or a battery that is not designed for the cold. I would recommend having your battery test at your local autoparts store.
155 views
Usually answered in minutes!
×