Heated seats will not come on and drivers side seat does not work at all. fuses have been check are there more fusesto check??

Heated Seats
This system allows the electrical heating of the front seats on passenger demand.
The components of the system are:

• the seat heating elements located in the seat cushion and backrest.
• the heated seat control switch, located on the seat side trim panel.
• temperature sensors located in the seat cushion heating elements.
• heated seat relay.

Do both front seat heaters not work ? Do you know how to test electrical circuits with voltmeter ?
PINPOINT TEST J: THE HEATED SEAT IS INOPERATIVE Test Step Result / Action to Take J1 CHECK HEATED SEAT SWITCH OPERATION

• Key in ON position.
• Press the heated seat switch on the driver and passenger seats.
• Are both heated seat switch indicators illuminated?

Yes
If both indicators illuminate, Go To Pinpoint Test K . If only one indicator illuminates, GO to J5 .

No
GO to J2 . J2 CHECK THE HEATED SEAT RELAY CIRCUITS

• Key in OFF position.
• Disconnect: Heated Seat Relay C3250 (located under the driver seat).
• Key in ON position.
• Measure the voltage at heated seat relay C3250-86, circuit 1003 (GY/YE), harness side and ground; and between C3250-30, circuit 566 (DG), harness and ground.
  
• Are the voltages greater than 10 volts?

Yes
GO to J3 .

No
REPAIR inoperative 1003 (GY/YE) or 566 (DG) circuit. TEST the system for normal operation. J3 CHECK HEATED SEAT RELAY GROUND CIRCUIT

• Key in OFF position.
• Measure the resistance between heated seat relay C3250-85, circuit 57 (BK), harness side and ground.
  
• Is the resistance less than 5 ohms?

Yes
GO to J4 .

No
REPAIR circuit 57 (BK). TEST the system for normal operation. J4 CHECK THE HEATED SEAT RELAY

• Install a fused jumper lead between heated seat relay 3250-30, circuit 566 (DG), harness side and heated seat relay C3250-87, circuit 1064 (YE/LB), harness side.
  
• Do both heated seat indicators illuminate when pressed?

Yes
INSTALL a new heated seat relay. TEST the system for normal operation.

No
REPAIR circuit 1064 (YE/LB) to switches. TEST the system for normal operation. J5 CHECK INOPERATIVE HEATED SEAT SWITCH INPUT

• Key in OFF position.
• Disconnect: Heated Seat Switch C320 (Driver) or C321 (Passenger) for the inoperative heated seat.
• Key in ON position.
• Measure the voltage between heated seat switch C320-2 (driver) or C321-2 (passenger), circuit 1064 (YE/LB), harness side and ground .
  
• Is the voltage greater than 10 volts?

Yes
GO to J6 .

No
REPAIR circuit 1064 (YE/LB). TEST system for normal operation. J6 CHECK CIRCUIT 57 (BK) FOR AN OPEN

• Measure the resistance between heated seat switch C320-4 (driver) or C321-4 (passenger), circuit 57 (BK), harness side and ground.
  
• Is the resistance less than 5 ohms?

Yes
INSTALL a new heated seat switch. TEST the system for normal operation.

No
REPAIR circuit 57 (BK). TEST the system for normal operation It's not that simple , being a fuse . It's probably the relay or the heating element .
PINPOINT TEST K: SEAT DOES NOT HEAT BUT THE HEATED SEAT INDICATOR ILLUMINATES WHEN PRESSED ? Does it ?
Your best bet would be to take to a qualified repair shop .
Do

Check power to the switch! If power coming to switch then switch is faulty! If no power then check fuses!

Hello-
If your fuses are good, perhaps your heated seat switch is faulty. You can test the switch for connectivity using a meter to see if power is going through the switch when in the ON position. If the meter shows no power while in the ON position, replace the switch. If power is reaching the seat, then likely the heating element itself within the seat is the culprit.

Check underneath the seat for an inline fuse. It is a glass type fuse in a fuse holder that you have to push and twist to get out.-----------------------------------------------------------------------------
XPROG-M

Have you checked the fuse? Look in owners manual for the fuse block and see if the fuse is burnt.

hello, have someone check all fuses-and plugs for the power seat, they may be a relay for this problem, can call autoparts store and ask about any relays for the heated seats and the power seat, if thats not it you may have to replace, electric motor for seat, sounds like a fuse, the way it all quit working..

the grid in your seat has shorted out if the right one works The relay controls both seats so you diffently have a burnt grid

the seat heater element is bad,,the heated seat pad has a open, the wire burns a hold in it from wear and tear and then they dont work,its most likely the drivers side seat back,,,,

check the fuse on the panel, the fuse panel are located in the driver side right by the panel,and check the wires under the seat.