Timing chain diagram
SOURCE: Daihatsu Sirion
I assume you are changing the timing belt. I am a mechanic and although not familiar with your vehicle, you would usually locate the timing mark on the bottom pulley and line this up. Careful not to turn the engine over too hard as pistons can strike valves. then you should look for similar marks on the camshaft pulley[s], and line these up. Then fit belt. This has to be tensiond correctly which is important. Hope this helps. Mike the bike01.
SOURCE: Where i can buy new parts for my Daihatsu Sirion
This website has your parts for your car (although there were limited parts available for it) and they ship worldwide.
Hope this helps,
matt
SOURCE: Hi, Does anybody knows where power
Engine room black box near the batteri, has the fuses if i recall correctly.
SOURCE: my daihatsu sirion abs light was always on what is
Hi, the light is basically telling you that there is a problem with a sensor or the sensor circuit. Find the eobd 16 pin plug and bridge the fourth pin on the top and the fifth pin on the bottom row with the ignition off. Now turn the ignition on and the light will flash and display codes. The series of first flashes indicates tens n the second series shown after a longer pause between flashes. Eg code 21 would be 2 flashes then a pause and one flash thereeon. The codes can be gotten from toyota nation. This will direct you to which sensor is faulty. Once the repair is done pump the pedal eight times and the light should blink constantly. Now turn off the key and pull out the bridging wire. Enjoy!!
1,766 views
Usually answered in minutes!
×