Is there a recalls on the fog lights if not how to fix it

No special tools needed. The headlight you just need to remove two 10mm bolts to remove the headlight capsule and get to the bulb and the fog light you need to drop the lower air valance to get to the bulb from the back side of the housing. I think it is several 7mm bolts that hold the valance to the bumper cover.

Ryan, Does the fog light indicator on dash light up when you pull out the fog lamp switch? Also, Are you aware the fog lights won't work when high beam is on?

G'day natron, this is serious if ya haven't fixed it yet get back to me. Keep well Greg.

Hi, Easy way to get over this is run a cable from working fog light to none working fog light this should then work. Only other way must be the left fog light is not earthed properly run earth wire to the vehicles body. Please give feedback at [email protected] Thanks, Malcolm Campbell.

There is a recall on headlights for 2005 MINIS, but I also know that the front fog light issue is prevalent, so DOT (888) 327-4236 SHOULD BE NOTIFIED AND MINI USA at: 1 866-MINI USA. Are you asking how to replace the fog light? There are also manuals available for each car with detailed guides on maintenance so you can learn your own vehicle and do it yourself, or safeguard yourself from being overcharged by mechanics. I hope this helps somewhat for you! Look here. A few people have had this issue and also have it relate to further issues. They are working towards a recall.
http://newmini.wordpress.com/2009/02/17/mini-cooper-power-steering-failure/#comment-884

the tiny bulb that lights up the switch is burnt out, the bulb is supposed top last the life of the of the switch, but they do burn out, replace the switch, about $25.00

Sounds like your multifunction switch (i.e. the stalk that has the fog light switch) has burned out. This is a fairly common problem and the multifunction switch needs to be replaced.

The part (as I recall) costs < $100 (about 80, I think) and takes less than half an hour to replace.

there are no recalls on a 2004 neon

FROM: Lusty Kid:

Your fog lights should not work with high beam... they should work with the low beams. they are connected wrong, which probably drew too much current through the light switch burning out the contact points for the parking lights in the switch

Start by Fixing the fog light connections to work with low beams. Appears to me this was not factory installed. Aftermarket kit maybe! Then see if your parking lights work. If parking lights don't work still and everything else works, replace the light switch $50 at the dealer. The switch works the fog lamps when you pull out the knob to turn on the fog lamps when the lights are turned on. When the fogs are on you will see a little amber light to let you know your fogs are on. When you switch to high beam the fog lamps go off. Again if its not working that way, then is wired wrong. Needless to say, there should be connectors in the harness of the lights for the fog lamps. Use those if possible with the kit that you can get at the dealer, or you can splice the connector with those blue splicing clips sold at the auto part store. Make sure ground is ground when splicing and water proof the connection sith silicone and tape.

hi disconnect your fog light switch if this doesn,t knock them off you need to find the fog lights relay and replace it as the fog light circuit is shorted best of luck yates210456