But goes off and will stay off sometimes if the steering is not straight when started it comes on
SOURCE: check engine light on 1997 Honda accord EX
Hi
If the engine is running without any problems then The fault code which has flagged the checked engine light will either pertain to the upstream O2 sensor, a drop in catalytic efficiency, an EGR issue, or maybe even an EVAP issue.
A lot of EVAP issues can be resolved by simply ensuring that the fuel filler cap is on securely, otherwise a vacuum leak will be detected in the system and the check engine light will come on.
A drop in catalytic efficiency (P0420) is usually temporary and will stay away after a reset.
EGR issues can sometimes be rectified by removing the EGR valve and cleaning it, and the ports on the intake where it was sat, but there are occasions when it has to be renewed.
The O2 sensor issues are a wee bit different. There are a number of fault codes which relate to the O2 sensor, and which make the O2 sensor look faulty, when the O2 sensor is actually attempting to rectify a problem from elsewhere and isn't faulty at all. However, they could also be due to a fault with the O2 sensor. Basically, further checks should be made before condemning the O2 sensor should the fault code relate to the sensor.
Have a code read done and then have the codes reset and see what comes up.
Regards
Geordie
SOURCE: 92 Honda Accord
Blinking light means there is a trouble code.There is a procedure to manually pull codes from the computer.Have the codes checked,have them written down.It could be just shift solenoids,or could even be something more serious,but thats the starting point.
SOURCE: 1998 honda accord ex key light
hi you have a immobilizer problem its reading the key but not knocking it off its either the key reader or the ecu yates210456
SOURCE: I have 96 Honda Accord EX V6 engine,Engine start but stop
Nearby garage auto mechanic will be working on the problem
SOURCE: My speedometer stopped working on my 97 Honda Accord EX
HI, the speed sensor is damaged. replacing the sensor will fix this issue.
When the airbag light (SRS) is on or blinks it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called the clock spring contact, a coiled up ribbon electrical contact that turns with the steering wheel while maintaining a mechanical connection to the airbag mounted on the steering wheel, to replace this part you must disarm the airbag system and remove the steering wheel, this requires a special steering wheel puller tool and that you disarm the airbag system before you start the work, to do this disconnect the battery negative cable for 1/2 hour prior.
61 views
Usually answered in minutes!
×