Hey mate, get a can of SeaFoam and put half in a full tank of gas and the other half in your oil through oil filler cap. Make sure engine is warm BEFORE doing this. Let sit for about 20 minutes. If you can get it started, go for a 10 minute drive. If you can't get it started, check/ change ignition switch..then go for a drive. SeaFoam is about 12$ at Canadian tire if in Canada... cheers.
Ford crown victoria One click, you'll be enlightened bro, I'm a regular customer here........ Try it once
SOURCE: 2000 Ford Crown Victoria
when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC
SOURCE: car wont start
make sure to have a fuel pressure test done to it, it must to have a least 35 psi of pressure, also see if car is equiped with map sensor if it does unplug sensor and try to start the car, if start replace map sensor
SOURCE: 94 CROWN VICTORIA FUEL PUMP
Yes you can replace it. It is in the fuel tank. You will need to drain the tank and remove it to gain access to the fuel pump. A floor jack will help when lowering the fuel tank. If you fo to a dealer to do this you will be looking probably around $700.00 to replace the pump.
SOURCE: How to change a fuel pump on 1998 ford crown
you have to remove the fuel tank- it is located inside the tank
SOURCE: Location of fuel pump relay on a 2001 Ford Crown Vic
where is the fuel pump relay on a 2001 crown vic p71
146 views
Usually answered in minutes!
×