I went and bought the bulb and when i put it in it was barely on it was so dim you could barely see it , i replaced it two times yet it still wont work what else could it be , My park light works though
When you replaced bulb,all wiring and bulb connector looked good,no corrusion,wires not burned or strayed.With dim lights,means just a little power going to light bulb.Did you check the fuse in fuse box,could be a loose connectoion,check both fuses,left and right headlight.swap them out and see,if fuses are good then,it may be the headlight switch,which cost the most.Here's a link on how to replace.Here's the part.
SOURCE: Replace Dash light bulbs on 2004 Malibu Maxx
you need to take the hole dash out and on the back of the speed dash there are little bulbs take them out then replace them
SOURCE: how to replace headlight bulbs 1999 chevy malibu
Thanks Pierre!
Merci beaucoup!
Everything worked as mentionned. Be carefull with the plastic in the winter. Make sure to use a flat screw driver and get it close to the slider and not on the edge. I cracked one of the tongues. Those L shaped slots are under the plastic cover with the two big plastic plugs that you also remove with the flat screw driver
Pierre Godin, Boissevain Manitoba.
SOURCE: head light bulb replacement 2003 chevy trailblazer
Simple! (I have the same model as well) Pop off the front chevy grill - it's held on with spring clips. Then look at the headlight assembly - there are 2 slide clips on either side, near the top - they have a tab that is bent forward - lift them UP. It may take a little force as they are usually stiff. The headlight assembly can then be pulled off the car, and the bulbs replaced.
SOURCE: how to replace valve cover gasket 1998 chevy malibu
The first step is to remove all the parts that are in the way of you being able to remove the valve covers. (Ex.: air intake, loose wires etc.) Then you will need to remove your valve covers (using basic tools) and be very careful to not let anything get on your lifters, which your valve covers protect. Once you have the valve covers off compare the new gaskets to make sure they are the right size. Then remove the old gasket and replace with the new one using a high temp gasket sealant (available at any auto parts store) to attach the gasket to the valve covers. Then tighten down snug and check for leaks after replaced.
SOURCE: the headlights stopped working on 2005 chevy
Check power at both headlights. Often one goes out and you don't notice till the other goes out. if both have power change the bulbs...if not check the switch and fuses as well as the dimmer switch.
Testimonial: "Thanks for the help. Now I just need to know where that fuse is located as I don't have a manual for the car"
290 views
Usually answered in minutes!
×