Remove and replace ignition lock
SOURCE: POWER BRAKE BOOSTER REMOVAL,HELP!
remove master cly. from booster. then under dash remove clip & pin from brake pedal . pull carpet down remove 4 nuts . pull off booster..
SOURCE: replace heater core 1994 chevy g20 conversion van
Here a are the instuctions to remove it. I did not know if you have A/C or not so I included both for you.
REMOVAL & INSTALLATION
Without Air Conditioning
ALL MODELS
See Figure 1
CAUTION
When draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.
To install:
1990-95 MODELS With A/C
To install:
SOURCE: remove ignition switch
U must dis-arm the airbag 1st, disconnect the battery for 30 minutes before you begin work, then remove the airbag, the retaining screws are at the back of the steering wheel down in holes I believe, after that remove the safety clip at the top of the steering wheel threads, then the steering wheel nut, you will need a steering wheel puller to remove the steering wheel, they are about $10 from any parts store, after the wheel is removed remove the airbag clock-spring rotating contact, then remove the turn signal switch, there will be 3 screws holding the turn signal switch in, remove them, then remove the lower trim under the dash and crawl under and and disconnect the large flat connector at the bottom of column, this will allow u to pull the turn signal switch up and out of the way, don't force anything be patient, under the turn signal switch on the right of the area above the ignition lock cylinder u will see a black headed screw, it may be a tamper proof torx/star screw head or a phillips, remove it, then turn the ignition to the on position and slide the ignition switch out, reverse it all and put it back together. take your time, don't rush, good luck, contact me with any further questions.
SOURCE: 1993 chevy van g20 water pump replacement
you will need some fairly long wrenchs 15mm-16mm to get leverage on the spring loaded serp tesiner put a wrench on the pulley near the belt ? also loosen the 4 fan bolts on the water pump before you remove the belt ? ther are 7 fan shroud bolts you can split the fan shroud ? 2 bolts on the lower right and 2 on the left ? after you do this then you should be down to pulling off the fan and pulley just slides off ? then remove the 4 waterpump mounting boltss, scrape the old gaskets ? when this is done all you have left is to installthe fan studs from the old pump? you do this by screwing down 2 nuts on the stud then with 2 wrenchs lock the nuts together ? then unscrew the bottom nut ? keep doing that till all 4 are replaced? install the gaskets and add some silicone and reverse the process ? hope this helps repost thumbs up !!
SOURCE: replacing ignition switch in 2001 chevy silverado
Not the igniton switch, its the ingition cylinder and or the housing. The switch is not part of what you are really turning. It's connected to it via gears. The common problem is the key gets worn out and the tumblers wear also. Eventualy they do not line up right and will not make the "bar" drop in the cylinder to allow it to turn from the off positon. If you have the title in your name and the key has never been rekeyed or the code has been changed you can go down to a dealership with all of the info for the truck and they can cut you a key from the vin number. You can try that first before you put a cylinder and housing in it.
Testimonial: "I really appreciate this info it makes sense and hopefully this solves the problem. it gets really annoying not being able to start the truci"
213 views
Usually answered in minutes!
×