Driver side power window stopped working

The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps

1. Roll door glass down. 2. Disengage two clips attaching speaker grille to door trim panel. They are at the front of the grille, one near the top, and the other one at the bottom.
3. Remove three large washer-headed screws surrounding the speaker.
4. Remove access cover at front of door trim panel. Remove by prying at its rear edge. 5. Remove red courtesy reflector from lower tail or door. Disengage by prying at screwdriver notch at bottom of reflector.
6. Remove flag trim panel from door by prying off at two attachment clips points.
7. Remove seven screws attaching door trim panel to door. a. One screw is located at lower rear screw pocket. b. Three screws located along the bottom of door. c. One screw located inside handle opening. d. One screw located at the upper front. e. One screw in the pull cup. 8. Disengage two hidden clips attaching at the rear of the trim panel, by prying off at two attachment clip points. 9. Lift trim panel upward and away from door, disengage trim panel from upper retainer channel. 10. Disengage clip attaching latch linkage to back door handle. 11. Disconnect electrical connectors as necessary, including lower foot light, If equipped. 12. Remove door trim panel from door