It appears that above 1500rpm the car stabilizes. Also, the engine emergency light is displaying the following code faults : p0172, p1171,p0121,p0102. Thanks
SOURCE: check engine light code PO442
You likely won't notice any drivability problems. P0442 indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter.
The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage.
Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.
With a P0442, the most common repair is to Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, or Inspect the EVAP system for cuts/holes in tubes/hoses.
Good luck and hope this helps
SOURCE: volvo s60 idle sensor
if you could get your hands on a scanner to read some live data it would help your plight,there is a cam position sensor when you take of the the plastic head cover at the timing belt end,did you check plugs,it also might help to clean the maf with some contact spray,sounds like plugs
SOURCE: 2002 Volvo S60 with Engine fault codes
THE 445 IS THE EVAP PURGE VALVE IT MAY BE BAD BOTH 446 IS SAME VAVLE YOU NEED TO SEE IF THE HOSE ARE GOOD ON THIS VAVLE MAKE SHERE NO CRACKS IF NOT PULL HOSES AND SEE IF SOMTHING IN VAVLE ITS NEAR THE CANSTER AND THAT IS NEAR THE GAS TANK UNDER CAR PUT CHECK GAS CAP MAKE SHERE ITS TIGHT HOPE THIS HELPS
SOURCE: CODE 042 ON A VOLVO S60
Brake lights and cruise control are not set properly.
Easy check - are your brake lights coming on with just the usual light touch of the pedal? If not, then the microswitch that senses that your foot is on the brake needs to be adjusted or replaced.
220 views
Usually answered in minutes!
hello , well the car still shut off ,i cleaned the throttle pos body , it cant get the ralenti rpm , but now just is displaying one fault code p102 is maf 's and want a knoww if just ihave to replacement the maf sensor i dont want to buy it if im not sure thanks for you answer
×