Service Airbag warning on cluster in 04 Silverado 1500

An airbag warning light is no different than an engine warning light--you have to get the trouble codes read to find out where to start.
Check engine light on Part Ricks Free Auto Repair Advice

depending on which one it is, pass or driver seat, its within the female reciever of seatbelt. easier to remove seat and inspect wiring to pretentioner. check for open by unplugging it and check across connector w olhm meter. if no reading, its open and needs replacd. unhook your battery before attempting this.

{: ) That's a double warning reminder already from your cluster, which means that some of the airbag features in your vehicle may not work properly in the event of accident or crash. Better have it checked by a scan tool to determine what particular component in the airbag system is causing it.

YOUR VEHICLE HAS DETECTED A FAULT IN THE AIRBAG CIRCUIT IT WILL HAVE TO HAVE CODE RETRIEVAL DONE TO DETERMINE WHAT CAUSE LIGHT TO STAY ON,I URGE YOU TO DO THIS SOON AS WHEN AN AIRBAG SYSTEM HAS GIVEN A FAULT CODE AND TURNED ON THE LIGHT THE SYSTEM IS DIABLED AND WILL NOT PROVIDE PROTECTION IN ACCIDENT

First of all you need to get this problem fixed ASAP. While the airbag light is illuminated, your SDM (Sensing and Diagnostic Module aka: the brain of your airbag system) shuts of power to the airbags. In which, if you are in an accident your airbags will not deploy while this light is illuminated. You need to take your vehicle to a GM dealership. A Tech 2 scantool is needed to retrieve the code from the SDM. Hopefully it won't be a costly repair, but is something that defineatly needs to be corrected soon. Good luck and hope all works well.

Service the airbag system. You need to get it checked at the dealer.

the reason this usually happens is due to an open circuit in the coiled ribbon connector to the airbag from the steering column, the part is called the rotating clock spring contact.

I have a 2007 chevrolet silverado and my service airbag light came on. I was out camping with the sterio going and ran the batt low but their was enough juice to restart after about 10 min. On the way home the service light stayed on and i just fixed the problem which was a fuse under the hood in the main fuse pannel. It is very common due to low voltage on start up to blow a 15 amp fuse.

This is either a problem with one or both of your airbags or the airbag connector located at the back of the glovebox has been disconnected for some reason. (ie. to prevent airbag opening when installing baby seat) (1999 miata does not have a baby seat airbag disabling sensor).

You should get your car inspected at your local mazda service to check if this is a wiring (plug disconnected) issue or one of your airbags is malfunctioning and needs to be replaced.

Flashing airbag light could indicate that either one of the airbags or both have a problem. Disconnecting the passenger's airbag has the same effect.

Warning! Do NOT attempt to do any kind of airbag/airbag wiring related repair yourself. Airbag problems should be addressed ONLY by certified technicians at your local Mazda service. (Airbag fixing requires for example that the car battery is disconnected, you MUST NOT attempt anything with the car battery connected).


Hope this helps.