SOURCE: 2004 GMC Sierra High Oil Pressure
if it is electrical oil pressure sensor I would start there. The best way to see if you have a major problem is to use a mechanical oil pressure tester. Take off the oil pressure sensor and put the mechanical tester on. The tester should come with a Gage. If it comes within your trucks oil pressure range than all is fine and replace the sending unit and see if that don't help your problem.If the tester runs high then the oil pump is bad or your cam-bearings could be the problem. But with cam-bearings you would usually get a low reading.
SOURCE: 2003 GMC Sierra Knock sensor and oil pressure??
the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.
SOURCE: Where is the oil pressure sensor located on a 2003
It is on the top backside of the engine block, behind the intake manifold mounted into the top of the block. You will have to lean up over the engine to see it.
Testimonial: "Thanks for the help"
SOURCE: LOW OIL PRESSURE ON 2007 GMC SIERRA 1500. CHANGED
have it tested using a manual gage if still low then main baring ore most likely bad that would mean a over hall if is really low and bearings bad should be making rattle noise when started up first few seconds
Testimonial: "thanks alot.truck is not making a rattling noise.we did check it with a manual gauge.it read about 10 at idol. press. gets better as you incr speed"
SOURCE: Where is the oil pressure sending unit oa a 2005
my 2004 yukon engine oil sensor is at its highest, what is the problem
110 views
Usually answered in minutes!
×