Break lights dont work fuse is fine i think if it is under the hood it is good. not sure how to get bulbs out to check but seems wierd they both burn out at the same time.
Check the brake light switch located on the brake pedal arm. Its above the pedal under the dash and has a connector with several wires attached to it. The switch is either bad, broken, or out of adjustment. If you have to step on the brake to shift out of park there is also a another switch located there as well.
SOURCE: How do you replace the headlight bulb in 2003 Mitsu Outlander?
if you are removing the power clip, grab the recepticle it was plugged in to (look at your new bulb as a reference) and twist counterclockwise. The entire bulb assembly will come out, and replace with the new assembly.
SOURCE: fog lights not working
use a test light to check for power do this where you plug in your bulb is no power then trace wires testing in the wires periodically to check for broken wires if everything checks out fine next check the fog light switch.
SOURCE: brake lights wont work
Check the brake light switch which is located above the foot pedals on a metal bracket.
SOURCE: Brake lights not working
Like for like on the bulbs
chk your brale light switch at pedal arm...... good luck
SOURCE: i have a 2007 galant the right rear brake light
The taillight harnesses are very very problematic on the 2004-2008 Galants.
Pull your tail light out again, and take the bulb out of the socket and look into the socket. You should notice that the two little contacts are slowly melting into the connector.
The harness is available for about $20 at your local dealer. Most dealers stock them, as they fail regularly.
Testimonial: "i will try that thank you"
143 views
Usually answered in minutes!
×