SOURCE: oil pressure sending unit
Hi there;
Your looking foer the oil pressure sensor on the 2004 8.1L.
You will find it located directly behind the EGR valve threaded into the block just to the drivers side of the center bolt for the transmission to block connection.
Thanks
Farrout!
SOURCE: 2004 Grand Cherokee: oil pressure fluctuates
if you know for certain that the sending unit is correct and the guage is accurate, then yiu may have big problems.....while the engine is running open the oil filler hole.. is everything wet with oil? or does it look dry or just a little lubed? you can allways install an aftermarket oil pressure guage(crappy tire) if you get the same results with that then you may have a week oil pump....worst case scenerio... need an engine rebuild as the moter may have wear issues.does the pressure slowly drop as the motor warms up? at idle ? does it jump up when you step on the gas?
SOURCE: 2002 jeep wrangler oil pressure gauge drops
When the gauge is at 0, is there any noise from the engine (tick, knock etc?) I would have someone put a mechanical gauge on there and read true pressure.Your driving pressure seems OK but if the low number is "real" something is wrong!
SOURCE: difference between oil sending unit and the oil pressure switch
Same part...make sure you get one for gauge, not idiot light though. If the engine has any knocking or ticking when pressure drops do not drive it and have a mechanical gauge installed to check actual pressure. Parts often have different names for same item...your driveshaft is actually called a propeller shaft!!!
SOURCE: where is the oil pressure sending unit on a 1993 jeep grand
on the 4.0 motor Under hood, passenger side, lower engine area, rear of
distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side
of distributor, mounted in block.
467 views
Usually answered in minutes!
×