Replaced ignition module,relay switch,ignition switch,disbutor
Can we assume not a single thing was tested,
& you have no idea, if even one of those parts failed?
You need a wiring diagram & knowledge of how to test any
system or part of it- your trying to get working,installing part
after part- is not a solution
At this point I would suggest a repair shop
Ignition timing could be off.if engine wont crank first thing check for is fuel and spark.make sure spark plugs wires and spark plugs been replaced.do a spark test first could have bad ignition coil.if you are getting spark and good fuel pressure could have worn out timing belt or faulty pcm.do code scan first before buying new parts.
SOURCE: Engine turns but does not start items replaced so
Check the starter solenoid, or igintion switch
SOURCE: getting my truck to start
Sure I just replaced mine today. Its easy, first get a scratch awl or a very small pilips screw driver, put your key in the ignition and turn it to the postion where it would be if your vehicle would be in if the motor was running, next take that sharp scratch awl or small philips screw driver and on the botom side of the switch housing pointing to about your right knee when sitting in the drivers seat you will see a small hole just under the base of the ignition switch a small hole, put that sharp scratch awl in that small hole and with one hand wiggle the key back and forth in the running positon, you will feel the awl go in a little bit and after that pull the key and the ignition out of the side of the steering column, the key and the igntion will all come out as one unit. The same thing goes for putting the new one in place. Good Luck!!
SOURCE: 1995 s10 pickup 4wd just replaced fuel pump, won't start.
replace the wireing harnes to the fuel pump gm had problems with them cost around $15 to 26 at autozone
SOURCE: I have a 1995 Ford F350 with a 5.8 liter. The
the ignition control module what went on mine 76 bucks . Then the temp sensor for the computer.
SOURCE: CAR WONT START 1995 NISSAN MAXIMA GXE V6 REPLACED
it might be in your ignition still try turning it from the first click acc to stat and dont stop on the on position thats how mine is
387 views
Usually answered in minutes!
We tested all the old parts b 4 replaceing them . Truck still will not start timeing still good
×