First thing to check when the engine is cold is that if there is enough antifreeze in the radiator and after you run the engine for about 5/10 minuter check both the rad hoses to see if they are both at the same temperature, if the return hose which is the bottom one is cold then replace the thermostat. If both hoses are hot or same temp then make sure the radiator fan comes on?
The 99 taurus has a med temp. fan run and a higher temp fan comes on . the high temp fan is on the passenger side.
First thing to check is your thermostat
It's been 10 days......have you found the cause? Post back so we'll know,please? don-ohio
Make sure cooling fluid is on max!
Hope this helps
SOURCE: how to bleed the brakes for 2001 ford taurus
Please don't forget to rate:
Bleeding The Brake System
Bleeding
When any part of the hydraulic system has been disconnected for repair or replacement, air enters the lines causing spongy pedal action (because air can be compressed and brake fluid cannot). To correct this condition, it is necessary to bleed the hydraulic system to ensure all air is purged.
Always begin bleeding the brake system from the furthest wheel cylinder or caliper from the master cylinder; the right rear.
NOTE: The right side of the vehicle is the passenger side. The sides of the vehicle are determined from the driver's perspective. This reference is taken from sitting in the driver's seat, facing forward.
Maintain a full reservoir during the bleeding operation. Never use brake fluid that has been drained from the hydraulic system, or from an open container, no matter how clean it is. Always use brake fluid from a new, sealed container. The front and rear reservoir will drain as the front or rear brakes are bled.
SOURCE: I need a replacement keys for 2001 ford taurus
A good place to start is a ford dealer. Often they can cut you a key off the VIN number. You will have to go there in person., and some kind of proof of ownership would be needed!
357 views
Usually answered in minutes!
×