Valve job how much does it cost on 1997 isuzu rodeo 3.2l

SOURCE: FUEL FILTER

Passenger side of vehicle. Look under vehicle around the rear door area. Inline filter.
Buy the Haynes or Chiltons. Well worth it for the vehicle. Also hondaautomotiveparts(dot)com can get you decent prices on some items. Isuzu Rodeo and Honda Passport are the same car (made by Isuzu). It atleast has a good breakdown of parts with pictures.

SOURCE: 1997 Isuzu rodeo-dashboard light/air cond, heat not blowing

Easy fix. Usually the blower motor resistor gets messed up. (Page 3-8 Haynes manual 47017). The dash light could be a few things. All my bulbs went bad. Little bit of a hassle but no problem with the book.

SOURCE: 1997 Isuzu Rodeo. four-wheel drive

There's a vaccum switch on your front axle thats probably corroded and stuck. It's common, especially if you don't use very often. There could be other problems but this is most common. Of course check to see if the vaccum lines are still attached. Mines bad too and I could only find it at the dealer. It was $180.00. If your mechanically inclined, read about this on isuzuforums.com and buy manual front hubs and by pass this system. New warn hubs are only $80.00 and much stronger, this is a very easy modification.

SOURCE: 1997 Isuzu Rodeo, 4.2L All windows stopped working!!!

all windows controlled from the drivers door...if you have someone in the family with BIG fists have them stand beside the drivers door panel and putting the **** against the door, SLAM their fist into the door panel right under the switches. Take a can of WD-40 and spray ALOT directly around the switches in the door using the little red hose WD40 gives you. GM's are known for carbon-tracking their door mechanisms...build up over the years...sometime banging the door knocks the buildup loose allowing the circuit to work.

SOURCE: 1997 isuzu rodeo problems with the blower motor

You can test the blower motor by connecting a positive and negetive wire directly to the 2 terminals on the motor.
As far as the resistor goes. If the blower motor only works on high fan speed then the resistor is bad. If it works on all speeds except high, then the relay is bad. Good luck. Hope this helps.