Iat sensor where is my iat sensor for my dodge ram 1500 5.7L

P1509 Dodge - Leak Detection Pump Switch or Mechanical Fault

P1298 Dodge - Air/Fuel Ratio Lean Under Wide Open Throttle Condition
- Plugged air filter
- Plugged fuel filter
- Defective fuel pump
- Ignition system weak-misfires
- Defective coil

P0118 Dodge - Engine Coolant Temperature Sensor Circuit High
- Low engine coolant level
- Faulty Engine Coolant Temperature (ECT) sensor
- Faulty engine coolant thermostat
- Engine Coolant Temperature (ECT) sensor harness is open or shorted
- Engine Coolant Temperature (ECT) sensor electrical circuit poor connection

P0113 Dodge - Intake Air Temperature Sensor 1 Circuit High
- Faulty Intake Air Temperature (IAT) sensor
- Dirty air filter
- Intake Air Temperature (IAT) sensor harness is open or shorted
- Intake Air Temperature (IAT) sensor circuit poor electrical connection

I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e

The IAT is on the intake manifold passenger side front with a two wire connector. It is right below the Breather cover ,corner where inlet tube from fender inters the cover.

Well, it's definitely on the intake manifold somewhere. On a Chrysler 2.5L v-6, the IAT is on the upper intake manifold, at the front of the engine (the farthest point from where air enters the intake). This is a transverse engine, but your IAT should be on the intake or plenum.

Relates to problem with I.A.T. sensor/circuit. Normally replacing I.A.T. sensor will fix it.
I.A.T. = Incoming Air Temperature.

depends on the engine...
3.7 liter, #1 below:



4.7 liter:



5.7 liter, #2 below:

on the intake manifold passenger side near the front i think

temp charge sensor is located on the air box, or tube leading to the throtlebody.

It could be any of the following
Internally failed IAT sensor
Faulty connection at IAT sensor
Open in IAT ground circuit or signal circuit
Short to voltage in IAT signal circuit or reference circuit
IAT harness and/or wiring routed too close to high-voltage wiring (e.g. alternator, spark plug cables, etc.)
Faulty PCM (less likely but not impossible)

Here is the location ...

1 - LEFT SIDE OF THROTTLE BODY 2 - ELEC. CONNECT. 3 - IAT SENSOR 4 - RELEASE TAB

If your looking for the Intake Air Temp/Manifold Absolute Pressure sensor (IAT/MAP)(2003 model year and up) It is on the top of the intake manifold, just to the left of the #3 injector fuel line. There are 2 small Torx screws holding it.