Question about 2003 Dodge Neon

1 Answer

How do i replace the alternaor wire connector

Need to replace the wiring connector on 2003 dodge neon se alternator. the original wires are green and black, the replacement plug has green, and greed with an orange stripe. which wires to i connect? the black w/ the green and orange, or black w/ the solid green? or does it matter?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 46 Answers

Connect the solid green with the solid green. and the others. if you have the connector with wires just match the position right and left one by one

Posted on Mar 10, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 99 Answers

SOURCE: my 2004 dodge neon 2&3 cylinder are not fireing

It seems like it may not have compression, where as all you need to do to test it is get an engine compression tester, which is a gaudge with a long extension on it to check your cyllender compression. remove all 4 spark plugs, have someone crank the engine over as you hold the gaudge in place. (it may make a pop noise ot a quick hiss if you don't hold down on the tester enough and sometimes when you release it) and if you have the new parts, and the plug is getting the spark, then it may be a head or heade gaskit issue. If you don't have a compression tester, you can usualy rent them at any advance auto parts or autozone. All you do is pay for the tool upfront, and when you return it you get all your money back.
Hope this helps!

Posted on Dec 14, 2008

ourhowse

Dar

  • 2007 Answers

SOURCE: replacing front turn signal socket on 1990 dodge shadow

Okay. Hook black to black.
Green to green with white stripe.
Yellow to red with white stripe.
That should work. Nothing is going to blow up if it's wrong. It just won't work.

Posted on May 15, 2009

pippall

Philip Long

  • 1486 Answers

SOURCE: I have 2003 dodge neon with code 303 missfire i

change the crank sensor

Posted on Jun 11, 2009

J F

  • 154 Answers

SOURCE: Fusible link wire gets really hot.

Removing the two smaller wires stops the exciter current to the alt which stops it charging.
Usually if a wire is getting hot its because:
A: Current overload..
B: Corrosion in wire restricting current.
C: Corroded terminal.

Posted on Jul 02, 2009

alicantecoli

Colin Stickland

  • 22484 Answers

SOURCE: dodge neon 2002. My alternator is not charging,

wires run direct to alternator from battery ,test big lead for a permanant 12v supplyon the back of the alternator if you have one then the problem is either the brushes worn out or the commutator worn through.or the regulator either way its a recon unit as parts are not sold seperate anymore as not many dealer mechanics know how to repair anything and the spares shops make more profit on a unit than parts so they do not sell spares to stop people like me and you from doing our own repairs

Posted on Jun 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge neon 2002 need help


i just had this same problem on my wife's 98. check the alternator to starter hot wire (at starter solenoid) hers was rusted not passing enough current to crank starter. 5 amp for solenoid, 80 amp for starter. jumper wire off battery worked every time. replaced connector and all good. coroded wires = higher resistance = lower amperage passing and possable fire-hazard

Dec 27, 2013 | 2002 Dodge Neon

1 Answer

Where can i find a wiring diagram for neutral safety switch for 2003 neon


The DK BLU/WHT wire from 15A fuse 10 in the fuse block connects to terminal 2 of the brake transmission shift interlock solenoid. The WHT/PINK wire from the brake lamp switch connects to terminal 1.

Apr 09, 2013 | 2003 Dodge Neon

1 Answer

P0622 code appears,pulled dk green wire to check for short,unplugged off altnator did continutity test,was no short in wire to pcm plug in Hooked up to pcm intermitted readings showing short.Do I need new...


Your best bet would be to go to an alternator rebuilding shop and have them test the alternator. They should be able to advise you. Sometimes, a different voltage regulator can be installed in the alternator if the one in the PCM goes bad. This was done on a lot of Dodge vehicles some years back. Lots cheaper than buying a new PCM. Good luck, and let us know what you find out.

Sep 26, 2011 | 2003 Dodge Neon

1 Answer

I have a 2003 dodge neon sxt and i can locate the alternator but i dont see how to take if off please help


To remove the alternator you will need to raise the front of the car and block the rear wheels. Disconnect the negetive wire from the battery. Loosen the upper alternator adjustment boltnut. Remove the right front tire and the accessory drivebelt splash shield. Loosen the alternator lower mounting bolt. Remove the alternator drive belt and disconnect the electrical connectors from the alternator. Remove the upper and lower adjustment bolts and remove alternator. You will have to remove the alternator bracket when you lower the alternator down. Installation is the reverse of removal. Hope this will help you.

May 16, 2010 | 2003 Dodge Neon

1 Answer

Different wiring plugs


If it were me, I'd cut off the connectors and switch them, but I solder things every day. I don't think they make any adapter wiring harness for this problem.

Dec 16, 2009 | 2001 Dodge Neon

4 Answers

2005 Neon SXT Stereo Wiring Diagram


2005 Dodge Neon Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Pink/Light Blue
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Orange
Car Stereo Dimmer Wire: Black/Yellow
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

Jun 19, 2009 | 2005 Dodge Neon

2 Answers

Head lights will dim


You might want to check for a loose ground (negative) wire somewhere. That could explain the popping with the radio.

Jan 30, 2009 | 2004 Dodge Neon

Not finding what you are looking for?
2003 Dodge Neon Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...