2008 toyota highlander 3.5 water pump removal

SOURCE: reset oil maintenance light in

1. Set the "ENGINE START STOP" or engine switch OFF with the trip meter A reading shown.
2. While pressing the trip meter reset button, set the "ENGINE START STOP" switch or engine switch ON.

1. Continue to press and hold the button until the trip meter displays 000000.

1. Continue to press and hold the button until "COMPLETE" appears on the multi-information display.

SOURCE: 19" FACTORY TOYO TIRES SHREDDING

Toyo®, Exclusive Tire of 2008 Toyota Highlander Hybrid, Limited Grade
September 20, 2007– CYPRESS, CALIFORNIA – Toyo Tire (U.S.A.) Corporation announced today that the Toyo® Open Country® A20 is the exclusive tire of Toyota’s all-new 2008 Highlander Hybrid, Limited grade. In addition, the Open Country® A20 is original equipment on several other models of the 2008 Toyota Highlander, both hybrid and gas.

The Open Country A20 achieved exceptional low rolling resistance performance making it ideal for the hybrid model. The tires were also specifically designed to reduce noise and improve both wet and dry braking for added safety.

Based on the model and trim level of the Highlander, the Open Country A20 comes in two sizes: P245/65R17 105S and P245/55R19 103S.

Toyo manufactures and distributes a complete line of replacement tires for high performance cars, luxury vehicles, light trucks and SUVs as well as tires for commercial trucks, buses and off-road and construction applications.


I'm surprised if it's so good at braking that it has not ripped my entire tire tread off as technicians say the treat is separating well before its time!

SOURCE: 2008 Toyota Highlander alarm goes off for no

You most likely have a bad hood latch switch you can unplug this switch until you get it repaired to stop the alarm from going off.
See Toyota TSB
T-SB-0331-08

SOURCE: How do you replace the

remove the screws in the tail light housing. Either there will be 4 screws on the outside holding the housing, or there will be two plastic wing nuts on the inside behind the rear liner. Oce the screws or nuts are removed, then you can gently pry off the plastic tail light lens.

SOURCE: How do I replace the battery in my keyless remote

You will need a 1632 Watch Electronics battery to begin. Press the bottom portion of the button/lever on the side of the key fob ( it says push and has a picture of a key on it). This lever will is on a spring and will push in, comparable to a door. Remove the key. Using the key or flathead screwdriver, insert the flat end into the opening, made visible by removal of the key. Apply light pressure to the area: the two halves will separate. Carefully remove the circuit board to expose your battery compartment, change battery and reverse operations.