1984 chevy S10 windshild wipers

Question 1

0helpful

1answer

How to remove wiper arm from 1979 Chevy van

If there is a screw on the top of the wiper arm remove it and pry up on the arm and it will come off the gear as it is pressed on. Hope this helps. To reinstall just line up the gear spline and tap down to seat the arm.

Feb 13, 2015 • 1984 Chevrolet Sportvan G30

2helpful

1answer

I have a 92 chevy S10 truck, how do you remove the wiper blades and arms?

GM S10/S15/Sonoma Pick-Ups 1982-1993 Repair Manual Blade and Arm - REMOVAL & INSTALLATION
(see Figures 1, 2 and 3)

Matchmark the base of the wiper arm to the linkage. This will assure the arm is installed in the proper position. If the arm is being replaced, transfer the matchmark from the old component to the new one before installation. This can be done by placing the new arm on top of the old one and copying the mark.

Fig. 1: Removing the wiper arm using J-8966

Fig. 2: If no wiper arm tool is available, use a small prytool to depress the spring

Fig. 3: With the spring released, pull the wiper arm from the linkage

Most wiper arms are retained by a spring clip. Some are equipped with a release tab at the center which should be depressed to release the arm. If no tab is provided, use a small prybar or a wiper arm removal tool such as J-8966 to depress the spring and release the arm. Remove the arm from the vehicle.
Some late model vehicles (all 1993 and some earlier models) are equipped with a wiper arm that utilizes a small release hole at the base of the wiper arm. If equipped, insert a 1 / 8 in. drift pin into the tool access hole to release the locking device and allow the arm to be easily pulled from the transmission. If necessary, use a gentle rocking motion to remove the arm.

To install:

Except for late model vehicles equipped with the tool access hole, align the matchmarks and gently press the blade over the linkage and snap into position.
For 1993 vehicles (and earlier models equipped with the access hole on the arm) straighten the arm assembly and insert the pin. Align the arm with the linkage mark made earlier, then press down on the arm's head casting until it seats and locks onto the wiper pin. Remove the drift pin.
Operate the wipers and verify proper alignment.

Hope helps (remember rated this).

Jul 08, 2010 • 1992 Chevrolet S-10

2helpful

1answer

When I turn on the windshield wipers they travel too far hitting the windshild pillar(top) and the the cowl(bottom).

The wipers are not installed correctly. Remove and reposition the wiper arms ,so they do not hit the side of the outside window pillar,when set to high speed.

Apr 28, 2010 • 2003 Honda CR-V

7helpful

1answer

How do you remove the windshield wiper arms

The wiper arms have a push in tab at the very bottom at the fitting that is pressed into the wiper linkage below the screen. Use a flat headed screwdriver to pry out the tab. Once out the arm can be pulled right off. Now you can remove the cowling screen

Apr 07, 2010 • 1987 Chevrolet S-10 Pickup

1helpful

2answers

As I was driving my 92 Dodge Dakota with the wipers on, I heard a sound and they stopped moving. I can hear the motor running. Do you have a suggestion for this and what parts might be needed to fix it?

had the same problem with mine all you need is a windshild wiper bushing it bout 5 to 10 $ at auto zone there are about 2 or 3 bushing that may need replacing mine was simplest one the one on the motor its easy it justs snaps onthe motor arm and than to the arms of the windshild transmistion

Oct 15, 2009 • 1992 Dodge Dakota

0helpful

1answer

Windshield wipers

You might have a stripped wiper arm spline. Check it by seeing if it moves with your hand. Also check wiper arm connection under the black plastic unscrew and remove black plastic.

May 06, 2009 • 2000 Mazda MPV

2helpful

1answer

1984 S10 wiper arms

No Problem! Look down on the Bottom of the Wiper Arm, wher it attaches and Swivels. There is a Small tab that comes off of the Upper Part of the Arm that looks like Two Front Teeth Sticking up just a Little. Take a Pair of Pliers and Pull this Tab Up Towards the Top of the Winshield to Release the Lock on the Arm. then take a Pair of Pliers with Tape on them so that you will not Scratch the Arm and Pull while you Wiggle the Arm right at the Swivel Pont and they will Come off. Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 28, 2009 • 1984 Chevrolet S-10

0helpful

1answer

Windshild wipers stuck on 96 ford explorer

go to bottom of arm take end cap off loosen bolt / Turn on wipers Check to here the motor if its running if its running turn off and tighten up the bolt wiper arm at bottom then turn the wipers on if you here the motor running if you do not check fuse under dash and in engine compartment / Please rate my response thank you very much

Jan 28, 2009 • 1991 Buick Park Avenue

0helpful

1answer

1984 s10 winsheld wipers

This is a very common Problem with Chevy Trucks. On my 95' Silverado, I had to Replace 5 Wiper Motors before She found one that she Liked. Even the Newer Trucks are Having the Same Problem with the Motors. Just Replace the Old one and get the Warranty with the New one. Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 27, 2009 • 1984 Chevrolet S-10

0helpful

2answers

My 2001 Buick Regal driver side wind shield wiper arm is stripped, it wipes at random. Please help

i don't know what you mean by stripped, but iam gessing you mean it won't stay on the windshild when it wipes. have you tride another blade? if not i would try that first. if that dosent work you may have to try another wiper arm. all wipers will do what yours is doing when conditions are just right. you can minamise this problem maybe with a double wiper blade. hope this will help. OLD SCHOOL.

Jan 10, 2009 • 1996 Buick Regal Olympic Gold

Question 2

Anonymous

Master 840 Answers
Posted on Jan 29, 2009

Anonymous

Master

Joined: Jan 24, 2009

Answers

840

Questions

0

Helped

424123

Points

2495

At the arm remove the cap on end and their is a nut remove it 10 mm / Please rate my response thank you very much

Answer 2 · 1/28/2009 12:00:00 AM

Anonymous

1990 Answers
Posted on Jan 28, 2009

SOURCE: 1984 S10 wiper arms

No Problem! Look down on the Bottom of the Wiper Arm, wher it attaches and Swivels. There is a Small tab that comes off of the Upper Part of the Arm that looks like Two Front Teeth Sticking up just a Little. Take a Pair of Pliers and Pull this Tab Up Towards the Top of the Winshield to Release the Lock on the Arm. then take a Pair of Pliers with Tape on them so that you will not Scratch the Arm and Pull while you Wiggle the Arm right at the Swivel Pont and they will Come off. Please Rate my Response, I need all the Help That I can Get! Thanks!

Answer 3 · 1/28/2009 12:00:00 AM

Anonymous

1990 Answers
Posted on Jan 28, 2009

SOURCE: 1984 S10 wiper arms

No Problem! Look down on the Bottom of the Wiper Arm, wher it attaches and Swivels. There is a Small tab that comes off of the Upper Part of the Arm that looks like Two Front Teeth Sticking up just a Little. Take a Pair of Pliers and Pull this Tab Up Towards the Top of the Winshield to Release the Lock on the Arm. then take a Pair of Pliers with Tape on them so that you will not Scratch the Arm and Pull while you Wiggle the Arm right at the Swivel Pont and they will Come off. Please Rate my Response, I need all the Help That I can Get! Thanks!

Related Topics:

Trustworthy Expert Solutions

1984 chevy S10 windshild wipers

1 Answer

Anonymous

1 Related Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

How to remove wiper arm from 1979 Chevy van

I have a 92 chevy S10 truck, how do you remove the wiper blades and arms?

When I turn on the windshield wipers they travel too far hitting the windshild pillar(top) and the the cowl(bottom).

How do you remove the windshield wiper arms

As I was driving my 92 Dodge Dakota with the wipers on, I heard a sound and they stopped moving. I can hear the motor running. Do you have a suggestion for this and what parts might be needed to fix it?

Windshield wipers

1984 S10 wiper arms

Windshild wipers stuck on 96 ford explorer

1984 s10 winsheld wipers

My 2001 Buick Regal driver side wind shield wiper arm is stripped, it wipes at random. Please help

Not finding what you are looking for?

1984 S-10

How to remove wiper arm from 1979 Chevy van

Ask a Question

Check Out the Latest Top Trucks Report!

Top Chevrolet Experts

ZJ Limited

Ronny Bennett Sr.

john h

Are you a Chevrolet Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Trustworthy Expert Solutions

1984 chevy S10 windshild wipers

1 Answer

Anonymous

1 Related Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

How to remove wiper arm from 1979 Chevy van

I have a 92 chevy S10 truck, how do you remove the wiper blades and arms?

When I turn on the windshield wipers they travel too far hitting the windshild pillar(top) and the the cowl(bottom).

How do you remove the windshield wiper arms

As I was driving my 92 Dodge Dakota with the wipers on, I heard a sound and they stopped moving. I can hear the motor running. Do you have a suggestion for this and what parts might be needed to fix it?

Windshield wipers

1984 S10 wiper arms

Windshild wipers stuck on 96 ford explorer

1984 s10 winsheld wipers

My 2001 Buick Regal driver side wind shield wiper arm is stripped, it wipes at random. Please help

Not finding what you are looking for?

1984 S-10

How to remove wiper arm from 1979 Chevy van

Related Topics

Ask a Question

Popular Questions

Chevy S10 Tail Light issue

How do i bypass the security on my chevrolet s10

Engine Code P1870

2001 Chevy s10 with no heat

4.3 v6 connecting rods and main bearings torque specs

Check Out the Latest Top Trucks Report!

Top Chevrolet Experts

ZJ Limited

Ronny Bennett Sr.

john h

Are you a Chevrolet Expert? Answer questions, earn points and help others

Manuals & User Guides