I removed the key, opened the back and battery still will not come out. I tried to force the case open, but I broke it a bit.
Step 1:
Using a small flat bladed tool, carefully remove the battery cover on the back of the fob.Step 2:
Remove the battery one at a time by slightly lifting up and sliding out from the fob.Step 3:
Replace the battery with the same type of battery cell.Step 4:
Install the battery with the positive side up.Step 5:
Install the battery cover and snap into place.Step 6:
Test for fob operation.
SOURCE: Rear hatch on 2000 dodge caravan wont open
you have to remove the door panel from the inside and replace the handle or open the latch.
SOURCE: the trunk won't open w/ remote or elct. sw. only
Hello. Chances are that the Unlocking mechanism in the trunk is either out of alignment or broken. Take a close look at it. It is where the trunk lid actually latches and locks. See if it is loose, or bent, or broken.
SOURCE: 96 Caravan Sport back door won't open
remove the panel from the rear hatch and you will notice a piece of the sound deadener has moved up against the power lock activater,the sound deadener is made up of a rubbery tar kind material that goes almost gooey when warm,as far as the key,keep spraying a penetrating oil inside the door lock and gently but forcibly work the key in and out and back and forth but do not twist too much and break the key off
SOURCE: 1998 dodge ram 1500 van side door will not open
step 1.Remove steering wheel horn cover
step 2.Remove steering wheel retaining nut (disconect airbag if so equipped)
step 3.Using moderate force remove wheel from steering column
step 4.Discard vehicle (donate,push off cliff,leave on train tracks,ect)
step 5.Purchase new vehicle (preferably a non-lemon)
step 6.Swap steering wheel with one from step 3
step 7.Enjoy the feeling of having "fixed" your auto troubles
SOURCE: how do I get the battery out of a keyless remote
Well first thing to do would be to take it off the key ring as it will get in the way.
If there is no small screw on the back, then there tends to be an indent on one of the corners of the casing. Usually a Penny would work for this. By putting the Penny in the groove and twisting with light pressure, the casing should pop.
If there is no easy pop groove or screw, use a small
flat-head screwdriver and gently pry the two sides apart. Working your way around the outside of the casing.
They should
pop apart, and you will see the battery.
Replace the battery and snap
the remote back together (this may take a bit of pressure).
If you have trouble go to the dealer and ask someone in parts, or service to show you how. They shouldn't charge you for asking how to take the cover off.
843 views
Usually answered in minutes!
×