Question about 2007 Ford Edge SEL Plus

1 Answer

2007 ford edge abs and traction control light came on this morning and stayed on

When i started the car the abs and traction control light came on on the dashboard and would not go off. I even hit the button several times to turn it off but to no avail

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

The most likely cause is a faulty wheel speed sensor,
there are four,one on each wheel.
you will need to plug in a diagnostic tool to determine which one.

Posted on Jan 28, 2013

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
michigan man

edgar walker

  • 3533 Answers

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Jan 12, 2010

daveleeyates

  • 65 Answers

SOURCE: Ford Focus 2001 ABS, Traction Control and Emergency Breake lights

You need to get a diagonstic check as sooon as the light comes on, dont turn ignition off as thi may delete the fault code Good luck Davelee

Posted on Mar 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Ford Edge the gear shift locks up and the traction control light stays on and when I manually push the sensor button down by the brake the traction light goes off and I can drive then.


Sounds like the brakeswitch you are pressing by hand is not in the proper position. What often happens is your feet knock off the switch and the safety setup locks the gearshift because you are suppose to have your foot on the brake before you can shift out of gear. Can not comment on traction light.

Jan 17, 2017 | Ford Cars & Trucks

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

Why does my 2007 Pontiac Montana van Traction Control light stay on?


the abs and traction control are tied together on all wheel drive cars most likely you have a bad wheel sensor

Jul 30, 2014 | 2007 Pontiac Montana

1 Answer

My 2007 ford edge abs and traction light is on


Your ABS and traction control use the same sensors. one is probably knocked out of alignment or bad, and it takes special equipment to get them right. Take it to an alignment shop, as they are cheaper than dealerships if you don't have warranty left.

Mar 01, 2011 | Ford Edge Cars & Trucks

1 Answer

ABS & traction control just went out on 2008 Ford Escape.


Chances are it is a bad ABS sensor. Need to get scanned to know for sure and which one.
Not much i know but I hope that helps.

Feb 03, 2010 | 2008 Ford Escape

1 Answer

2007 ford edge, three lights are on: ABS, wrench


it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Jan 12, 2010 | 2007 Ford Edge SEL Plus

1 Answer

Abs/traction control light is on? 2007 for focus wagon


You most likely disconnected the wireing harness. Check the plugs at the brakes.

Aug 07, 2009 | 2007 Ford Focus (3 Door) Hatchback

1 Answer

Ford Focus 2001 ABS, Traction Control and Emergency Breake lights


You need to get a diagonstic check as sooon as the light comes on, dont turn ignition off as thi may delete the fault code Good luck Davelee

Mar 17, 2009 | 2001 Ford Focus

1 Answer

ABS/CHECK ADVTRAC/SKIDDING CAR LIGHTS GO ON


The abs sensors also control the traction control and 4 wheel drive actuators so if one of the sensors is faulty the traction control will be disabled and the drive system will be stuck in the mode set at time of failure be that 4x4 or 2wd
get the abs system repaired

Jul 25, 2017 | 2002 Ford Explorer

Not finding what you are looking for?
2007 Ford Edge SEL Plus Logo

7,049 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...