Question about 1993 Dodge Caravan
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
It is on the firewall under the hood. It has 3 to 4 bolts holding on. Be careful when taking it out to see how the new one lines back up. Hope it helps.
Posted on Mar 30, 2009
If this is a factory wiper arm look at the area where it hinges. There should be a small hole in the metal. Find a drill bit or shaft that fits the hole. Lift up on the arm, insert the drill bit. When you release the arm it should be raised of the glass supported by the drill bit. Now without pressure applied to the glass you should be able to wiggle it off the shaft of the motor. Hope that helps.
Posted on Apr 01, 2009
Probably is the Body Control Module if you have checked the fuses in the fuse box and none are blown and you have verified power is coming to the wiper and signal switch. One simple fix you can try with the battery disconnected it to unplug and then replug the wriring harness to the BCM that fixed a Chrysler T&C that had the same problem. I also include what someone else gave as advice.
The body control module is located under the dash, directly behind the junction block that contains all the fuses/relays/plugs. The way you could verify that the wiring up to the bcm (from the wiper control) is working, before you go to the expense of replacing it, would be to locate the black plug on the bottom of the bcm (if you look under the junction block/bcm assembly you should see a gray connector and a black connector protruding from the underside of the bcm) and pull that plug, which is the one closer to the cowl. I believe you will find a dark green/yellow wire on pin #7 (from the wiper control) of the plug and a black/light green wire on pin #10 (ground). You may probe those wires with straight pins inserted thru the insulation so as to contact the internal conductor, then replace the plug (but make sure the straight pins don' touch oneanother), turn on the ignition switch to 'run', and measure the voltage between the two pins, you should find that the voltage will change proportionately as you cycle the wiper control through the six different positions of intermittancy. If not, then there is something the matter with the wiper control or its wiring. If the voltage is changing proportionately, then the manual does say to replace the bcm as the solution for that problem.
Posted on May 25, 2010
SOURCE: 2000 dodge caravan wipers dont
Heres a wiring diagram, this sounds like it may be a wiper module or a bad body control module, you have checked all your fuses and i assume they are good, heres a diagram to help you .
Posted on Oct 19, 2010
Tips for a great answer:
Feb 12, 2013 | 2003 Dodge Grand Caravan AWD
Sep 09, 2011 | 1998 Dodge Grand Caravan
Mar 04, 2011 | 1996 Dodge Grand Caravan
Jul 11, 2010 | 1993 Dodge Caravan
Apr 04, 2010 | 1996 Dodge Caravan
Dec 31, 2009 | 2003 Dodge Grand Caravan AWD
Sep 13, 2009 | 1996 Dodge Caravan
Aug 07, 2009 | 1997 Dodge Grand Caravan
Mar 12, 2009 | 1993 Dodge Caravan
132 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: