2004 ford f150
SOURCE: FORD F150 2004 SPARE KEY WONT START MY TRUCK
no, you will half to get it towed to dealer and have a computer chip key cut from your spare key then thay will program it to the vehicle
SOURCE: 2000 ford windstar won't crank over,but pats keys good, and batt.
First thing I would check is to see if you have power at the trigger wire of the starter motor while someone is trying to start the vehicle for you. It will be a Yellow with a light blue trace. If you do then I would check to see if the main battery cable has power to it all the time when someone is trying to crank it. If it does then I would hold a test light on the case of the starter motor and have someone try to crank it. Make sure that the ground you use for this test is on the negative battery terminal not just anywhere on the car. If the test light lights while you are cranking it then you have a bad ground. Hook up a set of jumper cables from the battery negative terminal and clamp it directly on to your starter motor and see if it starts. If you check it and the test light doesn't light up and all the other checks are good then your starter motor has failed. If one of the other tests has failed then you have a starter relay problem or something else. let me know what you find out.
SOURCE: Lost keys to 1998 Ford F150 Help
Mostly only ford dealerships would be able to issue a replactment
SOURCE: My 2004 F150 will not
the key has lost it's code, there is a chip in the key that communicates with the security system that the correct key is in the ignition and that the vehicle is allowed to start.
if you have any other keys on your key ring remove these and try again.
if no start and light still flashes the computer will need reprogrammed to accept the key.
the dealer can do this in like 10 -15 minutes usually.
SOURCE: no keys
If you want to initiate a new master key....
1. Insert new key into ignition cylinder and turn it to the ON (RUN) position. The security light on the dash will flash for fifteen minutes.
2. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder OFF and then back to the ON (RUN) position. The security light on the dash will flash for fifteen more minutes.
3. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes.
4. After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car. It has replaced ALL the previous electronic key codes and is the ONLY key programmed into the vehicles computer.
The dealership should be able to do this for you without a current key, of course this means towing the vehicle to them. See if they will sell you a key and you program it yourself.
hope this helps. I found the above info at FordF150.net
167 views
Usually answered in minutes!
×